A. entropy
B. enthaply
C. pressure
D. temperature
E. all of the above
Related Mcqs:
- One kg of steam sample contains 0.8 kg dry steam; it’s dryness fraction is__________________?
A. 0.2
B. 0.8
C. 1.0
D. 0.6
E. 0.5 - In an experiment to determine dryness fraction of steam, the mass of water separated was 1.2 kg in 15 mts and the mass of steam passed out in same time was 4.8 kg. Dryness fraction is__________________?
A. 40%
B. 25%
C. 50%
D. 80%
E. 90% - Expanding steam to a very low pressure (high vacuum) in steam engines is _________________?
A. desirable
B. economical
C. essential
D. optional
E. uneconomical - Vacuum for reciprocating steam engines compared to steam turbines is__________________?
A. more
B. equal
C. less
D. could be more or less depending on the size of plant
E. none of the above - Heating wet steam at constant temperature is heating it at constant_________________?
A. volume
B. pressure
C. entropy
D. enthalpy
E. none of the above - The size of a boiler drum in pulverised fuel fired boiler,as its size and capacity, (steam pressure and flow ratings) increase __________________?
A. increases
B. decreases
C. remains unchanged
D. increases/decreases depending on steam temperature requirements
E. unpredictable - An ideal flow of any fluid must satisfy __________________?
A. Pascal law
B. Newton’s law of viscosity
C. boundary layer theory
D. continuity equation
E. Bernoulli’s theorem - Slow plastic defomiation of metals under a constant stress is known as________________?
A. creep
B. fatigue
C. endurance
D. plastic deformation
E. non-plastic deformation - If partial pressure of air and steam be pa and ps respectively in a condenser, then according to Dalton’s law, the pressure in condenser is equal to__________________?
A. Ps-Pa
B. pa-ps
C. Pa+P
D. non of these - It is required to produce large amount of steam at low pressure. Which boiler should be used ?
A. pulverised fuel fired boiler
B. cochran boiler
C. lancashire boiler
D. babcock and wilcox boiler
E. stoker fired boiler