A. pressure lines
B. temperature lines
C. total heat lines
D. entropy lines
E. volume lines
Related Mcqs:
- Short horizontal lines on pressure-enthalpy chart show__________________?
A. constant pressure lines
B. constant temperature lines
C. constant total heat lines
D. constant entropy lines
E. constant volume lines - The lower horizontal line of the refrigeration cycle plotted on pressure-enthalpy-diagram represents_____________________?
A. condensation of the refrigerant vapour
B. evaporation of the refrigerant liquid
C. compression of the refrigerant vapour
D. metering of the refrigerant liquid
E. none of the above - On the pressure-enthalpy diagram, condensation and desuperheating is represented by a horizontal line because the process ________________?
A. involves no change in volume
B. takes place at constant temperature
C. takes place at constant entropy
D. takes place at constant enthalpy
E. takes place at constant pressure - Allowable pressure on high-pressure side or ammonia absorption system is of the order of_________________?
A. atmospheric pressure
B. slightly above atmospheric pressure
C. 2-4 bars
D. 5-6 bars
E. 7-10 bars - A certain refrigerating system has a normal operating suction pressure of 10 kg/cm gauge and condensing pressure of about 67 kg/cm. The refrigerant used is________________?
A. Ammonia
B. Carbon dioxide
C. Freon
D. Brine
E. Hydrocarbon refrigerant - The condensing pressure due to the presence of non-condensable gases, as compared to that actually required for condensing temperatures without non-condensable gases ____________________ ?
A. will be higher
B. will be lower
C. will remain unaffected
D. may be higher or lower depending upon the nature of non-condensable gases
E. unpredictable - Critical pressure of a liquid is the pressure_________________?
A. above which liquid will remain liquid
B. above which liquid becomes gas
C. above which liquid becomes vapour
D. above which liquid becomes solid
E. at which all the three phases exist together - The vapor pressure of refrigerant should be_________________?
A. lower than atmospheric pressure
B. higher than atmospheric pressure
C. equal to atmospheric pressure
D. could be anything
E. none of the above - Reducing suction pressure in refrigeration cycle_________________?
A. lowers evaporation temperature
B. increases power required per ton of refrigeration
C. lowers compressor capacity because vapour is lighter
D. reduces weight displaced by piston
E. all of the above - For proper refrigeration in a cabinet, if the temperature and vapour pressure difference between cabinet and atmosphere is high, then_________________?
A. bigger cabinet should be used
B. smaller cabinet should be used
C. perfectly tight vapour seal should be used
D. refrigerant with lower evaporation temperature should be used
E. refrigerant with high boiling point must be used
