If the evaporator temperature of a plant is lowered, keeping the condenser temperature constant, the h.p. of compressor required will be________________?

Related Mcqs:

1. The C.O.P of a refrigeration cycle with increase in evaporator temperature, keeping condenser temperature constant, will______________________?

   A. increase
   B. decrease
   C. remain unaffected
   D. may increase or decrease depending on the type of refrigerant used
   E. unpredictable

2. The C.O.P. of a refrigeration cycle with lowering of condenser temperature, keeping the evaporator temperature constant, will__________________?

   A. increase
   B. decrease
   C. may increase or decrease depending on the type of refrigerant used
   D. remain unaffected
   E. unpredictable

3. A refrigeration cycle operates between condenser temperature of + 27°C and evaporator temperature of- 23°C. The Cannot coefficient of performance of cycle will be_________________?

   A. 0.2
   B. 1.2
   C. 5
   D. 6
   E. 10

4. If a heat pump cycle operates between the condenser temperature of +27°C and evaporator temperature of – 23°C, then the Carnot COP will be_________________?

   A. 0.2
   B. 1.2
   C. 5
   D. 6
   E. 10

5. The change in evaporator temperature in a refrigeration cycle, as compared to change in condenser temperature, influences the value of C.O.P_____________________?

   A. more
   B. less
   C. equally.
   D. unpredictable
   E. none of the above

6. For better COP of refrigerator, the pressure range corresponding to temperature in evaporator and condenser must be____________________?

   A. small
   B. high
   C. euqal
   D. anything
   E. under some conditions small and under some conditions high

7. The refrigeration effect in a dry evaporator compared to flooded evaporator in a similar plant is_________________?

   A. same
   B. more
   C. less
   D. more or less depending on ambient conditions
   E. unpredictable

8. In a flooded evaporator refrigerator, an accumulator at suction of compressor is used to___________________?

   A. collect liquid refrigerant and prevent it from going to compressor
   B. detect liquid in vapour
   C. superheat the vapour
   D. collect vapours
   E. increase refrigeration effect

9. In refrigerator, liquid receiver is required between condenser and flow controlling device, if quantity of refrigerant for system is_____________________?

   A. less than 2 kg
   B. more than or equal to 3.65 kg
   C. more than 10 kg
   D. there is no such consideration
   E. pone of the above

10. Highest temperature encountered in refrigeration cycle should be________________?

    A. near critical temperature of refrigerant
    B. above critical temperature
    C. at critica. temperature
    D. much below critical temperature
    E. could be anywhere