A. 1000 J
B. 360 kJ
C. 3600 kJ
D. 3600 kW/sec
E. 1000 kJ
Related Mcqs:
- Mechanical equivalent of heat for 1 kcal or Joule’s equivalent is equal to_________________?
A. 421 kgm
B. 421 kgm
C. 539 kgm
D. 102 kgm
E. 75 kgm - The coal requirement per kW hour generation in the thermal power plant is of the order of__________________?
A. 0.1 to 0.2 kg
B. 0.2 to 0.4 kg
C. 0.6 to 0.8 kg
D. 1.0 to 1.5 kg
E. 1.5 to 2 kg - The evaporation of 15.653 kg of water per hour from and at 100°C is called_________________?
A. evaporative capacity
B. factor of evaporation
C. equivalent evaporation
D. one boiler h.p.
E. boiler efficiency - Equivalent evaporation is the amount of water evaporated in a boiler from and at ____________________?
A. 0°C
B. 100°C
C. saturation temperature at given pressure
D. room temperature
E. 20°C - The equivalent evaporation of a boiler is a measure to compare _________________?
A. the given boiler with the model
B. the two different boilers of the same make
C. two different makes of boilers operat¬ing under the same operating conditions
D. two boilers of same make but operaing under different conditions
E. any type of boilers operating under any conditions - Equivalent evaporation of water is the evaporation “for a feed water supply at 100°C__________________?
A. and its corresponding conversion into dry saturated steam at 100°C and 1.033 kg/cm2
B. and its corresponding conversion into dry steam at desired boiler pressure
C. conversion into steam at atmospheric condition
D. conversion into steam at the same pres-sure at which feed water is supplied
E. none of the above - Two pipe systems can be said to be equivalent, when the following quantities are same__________________?
A. friction loss and flow
B. length and diameter
C. flow and length
D. friction factor and diameter
E. velocity and diameter - The change in internal energy in steam engines equals to__________________?
A. work done during the rankine cycle ;
B. work done during compression.
C. work done during adiabatic expansion
D. change in enthalpy
E. none of the above - Maximum energy loss in a boiler occurs due to _______________________?
A. unburnt carbon in ash
B. incomplete combustion
C. ash content
D. flue gases
E. radiation losses - Boiler H.P. is defined as the ________________ ?
A. steam evaporation rate per kg of fuel fired
B. work done in evaporating 1 kg of steam per hour from and at 100°C into dry saturated steam
C. the evaporation of 15.65 kg of water per hour from and at 100°C into dry saturated steam
D. work done by 1 kg of steam at saturation condition
E. heat consumed in evaporating 1 kg water at 0°C to steam at 100°C and 1.033 kg/cm pressure