A. right hand with same pitch
B. left hand with same pitch
C. could be left or right hand
D. right hand with fine pitch
E. left hand with fine pitch
Related Mcqs:
- For standard coarse threads of nut, the threads will be as strong in failure by shear as the bolt in tension, if the height of nut (h) is approximately________________?
A. 0.4 times
B. 0.6 times
C. 0.7 times
D. 0.8 times
E. 0.9 times the normal diameter of bolt - The pitch of threads on a Jock nut in comparison to pitch of nut is_________________?
A. same
B. coarser
C. finer
D. very coarse
E. very fine - If shearing stress in nut is half the tensile stress in a bolt, then nut length should be equal to___________________?
A. diameter of bolt
B. 0.75 x diameter of bolt
C. 1.25 x diameter of bolt
D. 1.5 x diameter of bolt
E. 0.5 x diameter of bolt - When a nut is tightened by plaping a washer below it, the bolt will be subjected to following type of loads___________________?
A. compression
B. tension
C. shear
D. combined loads
E. all of the above - If d is the normal diameter of a bolt in mm, then the initial tension in kg in a bolt used for making a fluid tight joint as for steam engine cover joint is calculated by the relation_______________?
A. 102 d
B. 124 d
C. 138 d
D. 151 d
E. 168 d - When a bolt is subjected to shock loading, the resilience of the bolt should be considered in order to prevent breakage at_______________?
A. shank
B. head
C. in the middle
D. at the thread
E. anywhere in the bolt - The included angle in unified of American National threads is___________________?
A. 60°
B. 55°
C. 47°
D. 29°
E. none of the above - If an application calls for stresses on screw threads in one direction only, then the following type of thread would be best suited ________________?
A. square
B. acme
C. buttress
D. BSW
E. metric - Buttress threads are usually found on____________________?
A. screw cutting lathes
B. feed mechanisms
C. spindles of bench vices
D. screw jack
E. railway carriage couplings - Split nut is a locking device in which_________________?
A. one smaller nut is tightened over main nut and main nut tightened against smaller one by loosening, creating friction jamming
B. a slot is cut partly in middle of nut and then slot reduced by tightening screw
C. a hard fiber or nylon cotter is recessed in the nut and becomes threaded as the nut is screwed on the bolt causing a tight grip
D. through slots are made at top and a cotter-pin is passed through these and a hole in the bolt, and cotter pin splitted and bent in reverse direction at the other end
E. none of the above
