A. be independent of ratio of mass of load W to mass of bar (y)
B. increase with increase in y
C. decrease with decrease in y
D. depend on other considerations
E. none of the above
Related Mcqs:
- The maximum stress due to stress concentration in a bar having circular transverse hole, as compared to its static stress without hole will be_________________?
A. same in both cases
B. 2 times more
C. 3 times more
D. 4 times more
E. unpredictable - If an unsupported uniform cross sectional elastic bar is subjected to a longitudinal impact from a rigid bob moving with velocity v, then a compressive wave of intensity sc is propagated through the bar as follows______________________?
A. vpE
B. vVvF
C. WpE/2
D. IvHpE
E. none of the above, where E = modulus of elasticity and p = mass density - In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by_________________?
A. decreasing the cross-section area of’ bar
B. increasing the cross-section area of bar
C. remain unaffected with cross-section area
D. would depend upon other factors
E. none of the above - Oil in journal bearing should be applied at the point where load is________________?
A. nil or lightest
B. maximum
C. average
D. any one of the above
E. unpredictable - If shearing stress in nut is half the tensile stress in a bolt, then nut length should be equal to___________________?
A. diameter of bolt
B. 0.75 x diameter of bolt
C. 1.25 x diameter of bolt
D. 1.5 x diameter of bolt
E. 0.5 x diameter of bolt - Endurance limit or fatigue limit is the maximum stress that a member can withstand for an infinite number of load applications without failure when subjected to________________?
A. dynamic loading
B. static loading
C. combined static and dynamic loading
D. completely reversed loading
E. all of the above - The deflection of a cantilever beam under load W is 8. If its width is halved, then the deflection under load W will be________________?
A. 28
B. 8/2
C. 48
D. 8/4
E. none of the above - At low temperatures (say 75°C) the notched-bar impact value of steel____________________?
A. increases markedly
B. decreases markedly
C. remains same
D. depends on heat treatment carried out
E. none of the above - Stress concentration is caused due to_____________________?
A. variation in properties of material from point to point in a member
B. pitting at’points or areas at which loads on a member are applied
C. abrupt change of section
D. all of the above
E. none of the above - Shear stress theory is applicable for____________________?
A. ductile fnaterials
B. brittle materials
C. elastic materials
D. all of the above
E. none of the above
