A. 0.4 times
B. 0.6 times
C. 0.7 times
D. 0.8 times
E. 0.9 times the normal diameter of bolt
Related Mcqs:
- If threads on a bolt are left hand, threads on nut will be_____________________?
A. right hand with same pitch
B. left hand with same pitch
C. could be left or right hand
D. right hand with fine pitch
E. left hand with fine pitch - The pitch of threads on a Jock nut in comparison to pitch of nut is_________________?
A. same
B. coarser
C. finer
D. very coarse
E. very fine - If shearing stress in nut is half the tensile stress in a bolt, then nut length should be equal to___________________?
A. diameter of bolt
B. 0.75 x diameter of bolt
C. 1.25 x diameter of bolt
D. 1.5 x diameter of bolt
E. 0.5 x diameter of bolt - If d is the normal diameter of a bolt in mm, then the initial tension in kg in a bolt used for making a fluid tight joint as for steam engine cover joint is calculated by the relation_______________?
A. 102 d
B. 124 d
C. 138 d
D. 151 d
E. 168 d - When a nut is tightened by plaping a washer below it, the bolt will be subjected to following type of loads___________________?
A. compression
B. tension
C. shear
D. combined loads
E. all of the above - When a bolt is subjected to shock loading, the resilience of the bolt should be considered in order to prevent breakage at_______________?
A. shank
B. head
C. in the middle
D. at the thread
E. anywhere in the bolt - The ultimate strength of steel in tension in comparison to shear is in the ratio of__________________?
A. 1 : l
B. 2:1
C. 3 : 2
D. 2 : 3
E. 1 : 2 - For steel, the ultimate strength in shear as compared to ultimate strength in tension is ___________________?
A. same
B. 1/2
C. 1/3
D. 1/4
E. 2/3 - The included angle in unified of American National threads is___________________?
A. 60°
B. 55°
C. 47°
D. 29°
E. none of the above - If an application calls for stresses on screw threads in one direction only, then the following type of thread would be best suited ________________?
A. square
B. acme
C. buttress
D. BSW
E. metric
