A. metric
B. square
C. buttress
D. acme
E. BSW
Related Mcqs:
- Applications in which stresses are encountered in one direction only uses following type of threads____________________?
A. metric
B. buttress
C. acme
D. square
E. BSW - Guest’s theory of failure is applicable for following type of materials_________________?
A. brittle
B. ductile
C. elastic
D. plastic
E. tough - Rankine’s theory of failure is applicable for following type of materials___________________?
A. brittle
B. ductile
C. elastic
D. plastic
E. tough - Ball bearing type screws are found in following application_____________________?
A. screw jack
B. aeroplane engines
C. crane
D. steering mechanism
E. bench vice - For applications involving high stresses in one direction only the following type of thread would be best suited______________________?
A. ISO metric thread
B. acme thread
C. square thread
D. buttress thread
E. British Association thread - The following type of nut is used with alien bolt____________________?
A. alien nut
B. hexagonal nut
C. slotted nut
D. castle nut
E. any one of the above - When a nut is tightened by plaping a washer below it, the bolt will be subjected to following type of loads___________________?
A. compression
B. tension
C. shear
D. combined loads
E. all of the above - If an application calls for stresses on screw threads in one direction only, then the following type of thread would be best suited ________________?
A. square
B. acme
C. buttress
D. BSW
E. metric - For tight leakage joints, following type of thread is best suited ____________________?
A. metric
B. buttress
C. square
D. acme
E. NPT (national pipe threads) - Which of the following is not correct procedure to increase the fatigue limit_______________?
A. cold working
B. shot peening
C. surface decarburisation
D. under-stressing
E. all of the above
