A. steady
B. unsteady
C. laminar
D. vortex
E. rotational
Related Mcqs:
- The safety valve at superheater as compared to drum safety valve setting is set at___________________?
A. higher value
B. lower value
C. same value
D. any value
E. none of the above - The safety valve on boiler drum compared to safety valve on super heater is set at ________________?
A. same value
B. higher value
C. lower value
D. lower/higher depending on steam flow
E. unpredicatble - During the opening of a valve in a pipe line, the flow is_________________?
A. steady
B. unsteady
C. uniform
D. laminar
E. free vortex type - In order that flow takes place between two points in a pipeline, the differential pressure between these points must be more than_______________?
A. frictional force
B. viscosity
C. surface friction
D. all of the above
E. none of the above - What is the most common valve used in piping systems to throttle or regulate flow ?
A. Globe valve
B. Gate valve
C. Butterfly valve
D. Plug valveSubmitted by: Faheem Zaman Dhaunroo
- In the case of steady flow of a fluid, the acceleration of any fluid particle is________________?
A. constant
B. variable
C. zero
D. zero under limiting conditions
E. never zero - Leakage past the piston rings and valve seats in I.C. engines with increase in speed_______________?
A. increases.
B. decreases
C. remains same
D. unpredictable
E. none of the above - A safety valve in a locomotive starts leaking. The leaking medium will be_________________?
A. water
B. dry steam
C. wet steam
D. super heated steam
E. supersaturated steam - The feed check valve is used in order to ______________________?
A. regulate flow of boiler water
B. check level of water in boiler drum
C. recirculate unwanted feed water
D. allow high pressure feed water to flow to drum and not allow reverse flow to take place
E. none of the above - When the flow parameters at any given instant remain same at every point, then flow is said to be___________________?
A. quasi static
B. steady state
C. laminar
D. uniform
E. static