A. decreasing initial steam pressure and temperature
B. increasing exhaust pressure
C. decreasing exhaust pressure
D. increasing the expansion ratio
E. increasing number of regenerative heaters
Related Mcqs:
- The thermal efficiency of a two cycle engine as compared to four cycle engine is_________________?
A. more
B. less
C. same
D. more upto some load and then less
E. it may be less or more depending on several other factors - The efficiency of the ideal diesel cycle is ________ than that of Otto cycle, for the same compression ratio
A. Higher
B. Lower
C. Equal
D. None of theseSubmitted by: Faheem Zaman Dhaunroo
- Efficiency of a thermal cycle increases by ________________?
A. regeneration
B. reheating of steam
C. both A. and B.
D. cooling of steam
E. none of the above - 100% efficiency of a thermal cycle cannot be achieved because of __________________?
A. frictional losses
B. it is not possible to achieve 0°K temperature
C. leakage
D. non-availability of ideal substance
E. none of the above - Hot air standard diesel cycle efficiency with increase in value of C„_______________?
A. increases
B. decreases
C. remains unaffected
D. depends on other factors
E. unpredictable - The thermal efficiency of a semi-diesel cycle having fixed compression ratio and fixed quantity of heat, with increase in pressure ratio will_______________?
A. increase
B. decrease
C. remain unaffected
D. increase/decrease depending upon engine capacity
E. first increase and then decrease - In locomotives, the draught is produced by_________________?
A. chimney
B. induced draft fan
C. both combined A. and B.
D. steam jet draught
E. none of the above - Ignition timing of a multicylider petrol engine can be adjusted by_________________?
A. rotating the crank
B. adjusting the spark plug gap
C. adjusting ignition coil position
D. rotating the distributor
E. delaying the spark by increasing capacitor in ignition circuit - Recrystallisation temperature can belowered by_________________?
A. purification of metal
B. grain refinement
C. working at lower temperature
D. all of the above
E. none of the above - An ideal regenerative cycle is ______________________?
A. equal to carnot cycle
B. less than carnot cycle
C. more than carnot cycle
D. could be anything
E. none of the above