A. Power consumption per unit of air delivered is low
B. Volumetric efficiency is high
C. It is best suited for compression ratios around 7:1
D. The moisture in air is condensed in the intercooler
E. Outlet temperature is reduced
Related Mcqs:
- The advantage of multistage compression over single stage compression is ________________?
A. lower power consumption per unit of air delivered
B. higher volumetric efficiency
C. decreased discharge temperature
D. moisture free air
E. all of the above - For minimum work in multistage compression, assuming same index of compression in all stages_________________?
A. work done in first stage should be more
B. work done in subsequent stages should increase
C. work done in subsequent stages should decrease
D. work done in all stages should be equal
E. work done in any stage is no criterion for minimum work but depends on other factors - Which is false statement about advantages of multistage compressor in comparison to single stage compressor_________________?
A. less power requirement
B. better mechanical balance
C. less loss of air due to leakage past the cylinder
D. more effective lubrication
E. lower volumetric efficiency - In multistage compressor, the isothermal compression is achieved by_________________?
A. employing intercooler
B. by constantly cooling the cylinder
C. by running compressor at very slow speed
D. by insulating the cylinder
E. none of the above - Isothermal compression efficiency, even when running at high speed, can be approached by using A. multi-stage compression B. cold water spray C. both A. and B. above D. fully insulating the cylinder E. high stroke_________________?
Isothermal compression efficiency, even when running at high speed, can be approached by using
A. multi-stage compression
B. cold water spray
C. both A. and B. above
D. fully insulating the cylinder
E. high stroke - For a two stage compressor* if index of compression for higher stage is greater than index of compression for lower stage, then the optimum pressure as compared to ideal case will___________________?
A. increase
B. decrease
C. remain unaffected
D. other factors control it
E. unpredictable - Pick up the wrong statement about advantages of multistage compression____________________?
A. better lubrication is possible advantages of multistage
B. more loss of air due to leakage past the cylinder
C. mechanical balance is better
D. air can be cooled perfectly in between
E. more uniform torque, light cylinder and saving in work - Reheating in multistage expansion gas turbine results in____________________?
A. high thermal efficiency
B. reduction in compressor work
C. decrease of heat loss in exhaust
D. maximum work output
E. none of the above - Which is false statement about air receivers ___________________?
A. These are used to dampen pulsations ,
B. These act as reservoir to- take care of sudden demands
C. These increase compressor efficiency
D. These knock out some oil and moisture
E. These reduce frequent on/off operation of compressors - Pick up the false statement ?
A. gas turbine is a self-starting unit
B. gas turbine does not require huge quantity of water like steam plant
C. exhaust losses in gas turbine are high due to large mass flow rate
D. overall efficiency of gas turbine plant is lower than that of a reciprocating engine
E. gas turbine can be easily started and stopped and thus is best suited for peaking demands