A. provides greater flexibility
B. provides lesser flexibility
C. in never used
D. is used when gas is to be burnt
E. none of the above
Related Mcqs:
- The pressure ratio for an open cycle gas turbine compared to closed cycle gas turbine of same h.p. is_______________?
A. low
B. high
C. same
D. low/high depending on make and type
E. unpredictable - It is not possible to use closed gas turbine cycle in aeronautical engines because_________________ ?
A. it is inefficient
B. it is bulky
C. it requires cooling water for its operation
D. non of theses - A closed gas turbine in which fuel is burnt directly in the air is not possible because of__________________?
A. high pressure ratio
B. increasing gas temperature
C. high specific volume
D. high friction losses
E. paucity of 02 - The work ratio of simple gas turbine cycle depends on_________________?
A. pressure ratio
B. maximum cycle temperature
C. minimum cycle temperature
D. all of the above
E. none of die above - Open cycle gas turbine works on___________________?
A. Brayton or Atkinson cycle
B Rankine cycle
C. Carnot cycle
D. Erricsson cycle
E. Joule cycle - The following is true for an open cycle gas turbine having exhaust heat exchanger. Atmospheric air before entering the compressor is____________________?
A. heated
B. compressed air before entering the combustion chamber is heated
C. bled gas from turbine is heated and readmitted for complete expansion
D. exhaust gases drive the compressor
E. part of exhaust gases are heated and mixed up with atmospheric air to utilise exhaust heat - The ideal efficiency of simple gas turbine cycle depends on________________?
A. pressure ratio
B. maximum cycle temperature
C. minimum cycle temperature
D. all of the above
E. none of the above - For an irreversible gas turbine cycle, the efficiency and work ratio both depend on___________________?
A. pressure ratio alone
B. maximum cycle temperature alone
C. minimum cycle temperature alone
D. both pressure ratio and maximum cycle temperature
E. none of the above - Water is injected in gas turbine cycle to___________________?
A. control temperature
B. control output of turbine
C. control fire hazards
D. increase efficiency
E. it is never done - Gas turbine cycle with Regenerator __________________?
A. increases thermal efficiency
B. allows high compression ratio
C. decreases heat loss is exhaust
D. allows operation at very high altitudes
E. permits high moisture content fuel to be used