Pick up wrong statement ?
A. mass flow rate
B. pressure ratio
C. change in load
D. stagnation pressure at the outlet
E. all of the above
Related Mcqs:
- Surging is the phenomenon of___________________?
A. air stream blocking the passage
B. motion of air at sonic velocity
C. unsteady, periodic and reversed flow
D. air stream not able to follow the blade contour
E. production of no air pressure - A centrifugal compressor works on the principle of__________________?
A. conversion of pressure energy into kinetic energy
B. conversion of kinetic energy into presĀ¬sure energy
C. centripetal action
D. generating pressure directly
E. combination of A. and D. - The thrust on the rotor in a centrifugal compressor is produced by________________?
A. radial component
B. axial component
C. tangential component
D. resultant component - Losses in a centrifugal compressor are due to__________________?
A. inlet losses
B. impeller channel losses
C. diffuser losses
D. all of the above
E. none of the above - The ratio of outlet whirl velocity to blade velocity in case of centrifugal compressor is called__________________?
A. slip factor
B. velocity factor
C. velocity coefficient
D. blade effectiveness - Axial flow compressor has the following advantage over centrifugal compressor__________________?
A. larger air handling ability per unit frontal area
B. higher pressure ratio per stage
C. aerofoil blades are used
D. higher average velocities
E. none of the above - Phenomenon of choking in compressor means __________________?
A. no flow of air
B. fixed mass flow rate regardless of pressure ratio
C. reducing mass flow rate with increase in pressure ratio
D. increased inclination of chord with air steam
E. does not occur - The work ratio of simple gas turbine cycle depends on_________________?
A. pressure ratio
B. maximum cycle temperature
C. minimum cycle temperature
D. all of the above
E. none of die above - The ideal efficiency of simple gas turbine cycle depends on________________?
A. pressure ratio
B. maximum cycle temperature
C. minimum cycle temperature
D. all of the above
E. none of the above - Which is false statement about air receivers ___________________?
A. These are used to dampen pulsations ,
B. These act as reservoir to- take care of sudden demands
C. These increase compressor efficiency
D. These knock out some oil and moisture
E. These reduce frequent on/off operation of compressors