A. inductors
B. capacitors
C. synchronous motors
D. all of above
E. none of the above
Related Mcqs:
- For transmission of power over a distance of 200 km, the transmission voltage should be_________kv?
A. 132 kV
B. 66 kV
C. 33 kV
D. 11 kV - For transmission of power over a distance of 500 km, the transmission voltage should be in the range?
A. 150 to 220 kV
B. 100 to 120 kV
C. 60 to 100 kV
D. 20 to 50 kV - Constant voltage transmission entails the following disadvantage?
A. large conductor area is required for same power transmission
B. short-circuit current of the system is increased
C. either of the above
D. none of the above - Which of the following is the demerit of a ‘constant voltage transmission system’ ?
A. Increase of short-circuit current of the system
B. Availability of steady voltage at all loads at the line terminals
C. Possibility of better protection for the line due to possible use of higher terminal reactants
D. Improvement of power factor at times of moderate and heavy loads
E. Possibility of carrying increased power for a given conductor size in case of long-distance heavy power transmission - Transmission voltage of 11 kV is normally used for distances up to_____km?
A. 20—25 km
B. 40—50 km
C. 60—70 km
D. 80—100 km - High voltage transmission lines use__________________?
A. suspension insulators
B. pin insulators
C. both A. and B.
D. none of the above - The voltage regulation in magnetic amplifier type voltage regulator is effected by__________?
A. electromagnetic induction
B. varying the resistance
C. varying the reactance
D. variable transformer - The operating voltage of high voltage cables is up to_______________?
A. l.lkV
B. 3.3kV
C. 6.6kV
D. llkV - Series capacitors on transmission lines are of little use when the load VAR requirement is___________?
A. large
B. small
B. fluctuating
D. any of the above - Which of the following materials is used for overhead transmission lines ?
A. Steel cored aluminium
B. Galvanised steel
C. Cadmium copper
D. Any of the above
