A. ionizing air
B. absorbing moisture
C. cleansing the transformer oil
D. cooling the transformer oil
Related Mcqs:
- The function of breather in a transformer is___________?
A. to provide oxygen inside the tank
B. to cool the coils during reduced load
C. to cool the transformer oil
D. to arrest flow of moisture when outside air enters the transformer - The chemical used in breather is_______________?
A. asbestos fiber
B. silica sand
C. sodium chloride
D. silica gel - Which of the following is the main advantage of an auto-transformer over a two winding transformer?
A. Hysteresis losses are reduced
B. Saving in winding material
C. Copper losses are negligible
D. Eddy losses are totally eliminated - The changes in volume of transformer cooling oil due to variation of atmospheric temperature during day and night is taken care of by which part of transformer?
A. Conservator
B. Breather
C. Bushings
D. Buchholz relay - In a transformer the energy is conveyed from primary to secondary_________?
A. through cooling coil
B. through air
C. by the flux
D. none of the above - While conducting short-circuit test on a transformer the following side is short circuited?
A. High voltage side
B. Low voltage side
C. Primary side
D. Secondary side - The use of higher flux density in the transformer design____________?
A. reduces weight per kVA
B. reduces iron losses
C. reduces copper losses
D. increases part load efficiency - The value of flux involved m the e.m.f. equation of a transformer is____________?
A. average value
B. r.m.s. value
C. maximum value
D. instantaneous value - Which of the following properties is not necessarily desirable for the material for transformer core ?
A. Low hysteresis loss
B. High permeability
C. High thermal conductivity
D. Adequate mechanical strength - The maximum load that a power transformer can carry is limited by its________________?
A. temperature rise
B. dielectric strength of oil
C. voltage ratio
D. copper loss
