A. 6.8 kΩ

B. 2.2 kΩ

**C. 6.8 kΩ and 10 kΩ**

D. 2.2 kΩ and 1 kΩ

Advertisement

### Related Mcqs:

- The parallel combination of a 470 Ω resistor and a 1.2 kΩ resistor is in series with the parallel combination of three 3 kΩ resistors. A 200 V source is connected across the circuit. The resistor with the most current has a value of____________?
A. 470 Ω or 1.2 kΩ

B. 3 kΩ

**C. 470 Ω**

D. 1.2 kΩ - The parallel combination of a 470 Ω resistor and a 1.5 kΩ resistor is in series with the parallel combination of five 1 kΩ resistors. The source voltage is 50 V. The percentage of the load current through any single 1 KΩ resistor is__________?
A. 25 %

**B. 20 %**

C. 100 %

D. 50 % - Two 3.3 kΩ resistors are in series and this series combination is in parallel with a 4.7 kΩ resistor. The voltage across one of the 3.3 kΩ resistors is 12 V. The voltage across the 4.7 kΩ resistor is_________?
**A. 24 V**

B. 12 V

C. 0 V

D. 6 V - A 12 kΩ resistor, a 15 kΩ resistor, and a 22 kΩ resistor are in series with two 10 kΩ resistors that are in parallel. The source voltage is 75 V. Current through the 15 kΩ resistor is approximately___________?
A. 14 mA

**B. 1.4 mA**

C. 5 mA

D. 50 mA - Three 10 kΩ resistors are connected in series. A 20 kΩ resistor is connected in parallel across one of the 10 kΩ resistors. The voltage source is 24 V. The total current in the circuit is___________?
**A. 900 μA**

B. 9 mA

C. 90 mA

D. 800 μA - The parallel combination of a 470 Ω resistor and a 680 Ω resistor is in series with the parallel combination of four 2 kΩ resistors. The total resistance is___________?
A. 1,650 Ω

B. 1,078 Ω

C. 77.8 Ω

**D. 778 Ω** - In a series–parallel circuit consisting of R1 and R2 in series and connected in parallel with R3, if R1 opens, then R2‘s voltage will:___________?
A. increase

B. remain the same

**C. decrease**

D. cannot tell - A series resonant band-stop filter consists of a 68 Ω resistor, a 110 mH coil, and a 0.02 µF capacitor. The internal resistance, RW, of the coil is 4 Ω. Input voltage is 200 mV. Output voltage is taken across the coil and capacitor in series. What is the output voltage magnitude at f0?
A. 1.1 mV

**B. 11.1 mV**

C. 111 mV

D. 200 mV - A series resonant band-pass filter consists of a 2 mH coil, a 0.005 µF capacitor, and a 120 Ω resistor. The winding resistance of the coil is 12 Ω. The output voltage is taken off the resistor. Input voltage is 12 Vrms. What is the output voltage magnitude at the center frequency (f0)?
**A. 10.9 V**

B. 1.09 V

C. 1.1 V

D. 12 V - A voltage divider consists of two 100 kΩ resistors and a 12 V source. What will the output voltage be if a load resistor of 1 MΩ is connected to the output?
A. 0.57 V

B. 6 V

C. 12 V

**D. 5.7 V**

Advertisement