A. 3-Jan
B. 3
C. 1
D. 6
Related Mcqs:
- A series resonant band-stop filter consists of a 68 Ω resistor, a 110 mH coil, and a 0.02 µF capacitor. The internal resistance, RW, of the coil is 4 Ω. Input voltage is 200 mV. Output voltage is taken across the coil and capacitor in series. What is the output voltage magnitude at f0?
A. 1.1 mV
B. 11.1 mV
C. 111 mV
D. 200 mV - A series resonant band-pass filter consists of a 2 mH coil, a 0.005 µF capacitor, and a 120 Ω resistor. The winding resistance of the coil is 12 Ω. The output voltage is taken off the resistor. Input voltage is 12 Vrms. What is the output voltage magnitude at the center frequency (f0)?
A. 10.9 V
B. 1.09 V
C. 1.1 V
D. 12 V - If the secondary coil has Ns turns and the primary Np turns the relation between secondary and primary voltages is given by_____________?
A. Vs/Vp = Np/Ns
B. Vs/Vp = Ns/Np
C. Vp/Vs = Ns/Np
D. Vp/Vs = Np/Ns - A 500 turns solenoid develops an average induced voltage of 60 V. Over what time interval must a flux change of 0.06 Wb occur to produce such a voltage ?
A. 0.01 s
B. 0.1 s
C. 0.5 s
D. 5 s - At a certain frequency, the output voltage of a filter is 6 V and the input is 12 V. The voltage ratio in decibels is_____________?
A. 6.02 dB
B. -6.02 dB
C. 12.04 dB
D. -12.04 dB - A 200 turn coil has an inductance of 12 mH. If the number of turns is increased to 400 turns, all other quantities (area, length etc.) remaining the same, the inductance will be___________?
A. 6 mH
B. 14 mH
C. 24 mH
D. 48 mH - If a transistor amplifier draws 2mA when input voltage is 10 V, then its input impedance is ____________?
A. 20 kΩ
B. 2 kΩ
C. 10 kΩ
D. 5 kΩ - A sinusoidal voltage with a peak-to-peak value of 18 V is applied to an RC low-pass filter. If the reactance at the input frequency is zero, the output voltage is____________?
A. 18 V peak-to-peak
B. zero
C. 9 V peak-to-peak
D. 12.74 V peak-to-peak - In a certain low-pass filter, fc = 3.5 kHz.if the input voltage is a 6 V sine wave with a dc level of 10 V, what is the output voltage magnitude?
A. 0 V
B. 5.97 V
C. 6 V
D. 597 mV - In a certain low-pass filter, fc = 3.5 kHz. If the input voltage is a 6 V sine wave with a dc level of 10 V, what is the output voltage magnitude?
A. 0 V
B. 5.97 V
C. 6 V
D. 597 mV
Advertisement