A. 10°
B. 30°
C. 60°
D. 90°
Advertisement
Related Mcqs:
- In a capacitor start and run motors the function of the running capacitor in series with the auxiliary winding is to_______________?
- A. improve power factor B. increase overload capacity C. reduce fluctuations in torque D. to improve torque...
- A capacitor-start single phase induction motor is switched on to supply with its capacitor replaced by an inductor of equivalent reactance value. It will______________?
- A. start and then stop B. start and run slowly C. start and run at rated speed D. not start at all...
- In a capacitor start single-phase motor, when capacitor is replaced by a resistance____________?
- A. torque will increase B. the motor will consume less power C. motor will run in reverse direction D. motor will continue to run in same direction...
- In a two value capacitor motor, the capacitor used for running purposes is_______________?
- A. air capacitor B. paper spaced oil filled type C. ceramic type D. a.c. electrolytic type...
- In a split phase motor, the running winding should have?
- A. high resistance and low inductance B. low resistance and high inductance C. high resistance as well as high inductance D. low resistance as well as low inductiance...
- The running winding of a single phase motor on testing with meggar is found to be ground. Most probable location of the ground will be___________?
- A. at the end connections B. at the end terminals C. anywhere on the winding inside a slot D. at the slot edge where coil enters or comes out of the slot...
- The starting winding of a single-phase motor is placed in_________?
- A. armature B. field C. rotor D. stator...
- After the starting winding of a single phase induction motor is disconnected from supply, it continues to run only on ______________?
- A. running winding B. rotor winding C. field winding D. compensating winding...
- Starting winding of a single phase motor of a refrigerator is disconnected from the circuit by means of a___________?
- A. magnetic relay B. thermal relay C. centrifugal switch D. none of the above...
- If starting winding of a single-phase induction motor is left in the circuit, it will____________?
- A. run faster B. spark at light loads C. draw excessive current and overheat D. run slower...
Advertisement