A. reduce the effects of armature reaction
B. increase the torque
C. reduce sparking at the brushes
D. none of the above
Related Mcqs:
- The purpose of stator winding in the compensated repulsion motor is to_____________?
A. provide mechanical balance
B. improve power factor and provide better speed regulation
C. prevent hunting in the motor
D. eliminate armature reaction - A.C. series motor as compared to D.C. series motor has__________?
A. smaller brush width
B. less number of field turns
C. more number of armature turns
D. less air gap
E. all of the above - In a capacitor start and run motors the function of the running capacitor in series with the auxiliary winding is to_______________?
A. improve power factor
B. increase overload capacity
C. reduce fluctuations in torque
D. to improve torque - In a capacitor start motor, the phase displacement between starting and running winding can be nearly__________?
A. 10°
B. 30°
C. 60°
D. 90° - In a split phase motor, the running winding should have?
A. high resistance and low inductance
B. low resistance and high inductance
C. high resistance as well as high inductance
D. low resistance as well as low inductiance - The running winding of a single phase motor on testing with meggar is found to be ground. Most probable location of the ground will be___________?
A. at the end connections
B. at the end terminals
C. anywhere on the winding inside a slot
D. at the slot edge where coil enters or comes out of the slot - In split-phase motor auxiliary winding is of___________?
A. thick wire placed at the bottom of the slots
B. thick wire placed at the top of the slots
C. thin wire placed at the top of the slots
D. thin wire placed at the bottom of the slots - In split phase motor main winding is of _____________?
A. thin wire placed at the top of the slots
B. thin wire placed at the bottom of the slots
C. thick wire placed at the bottom of the slots
D. thick wire placed at the top of the” slots - Starting winding of a single phase motor of a refrigerator is disconnected from the circuit by means of a___________?
A. magnetic relay
B. thermal relay
C. centrifugal switch
D. none of the above - If starting winding of a single-phase induction motor is left in the circuit, it will____________?
A. run faster
B. spark at light loads
C. draw excessive current and overheat
D. run slower
