A. run for about 1 minute
B. run for about 5 minutes
C. picked up about 50 to 70 per cent of rated speed
D. picked up about 10 to 25 per cent of rated speed
Related Mcqs:
- Centrifugal switch disconnects the auxiliary winding of the motor at about ______ percent of synchronous speed?
A. 30 to 40
B. 70 to 80
C. 80 to 90
D. 100 - If the centrifugal switch does not open at 70 to 80 percent of synchronous speed of motor, it would result in_________?
A. damage to the starting winding
B. damage to the centrifugal switch
C. overloading of running winding
D. none of the above - If the centrifugal switch of a two-value capacitor motor using two capacitors fails to open then____________?
A. motor will not come up to speed
B. motor will not carry the load
C. current drawn by the motor will be excessively high
D. electrolytic capacitor will, in all probability, suffer break down - In a capacitor start motor, the phase displacement between starting and running winding can be nearly__________?
A. 10°
B. 30°
C. 60°
D. 90° - The starting winding of a single-phase motor is placed in_________?
A. armature
B. field
C. rotor
D. stator - After the starting winding of a single phase induction motor is disconnected from supply, it continues to run only on ______________?
A. running winding
B. rotor winding
C. field winding
D. compensating winding - Starting winding of a single phase motor of a refrigerator is disconnected from the circuit by means of a___________?
A. magnetic relay
B. thermal relay
C. centrifugal switch
D. none of the above - If starting winding of a single-phase induction motor is left in the circuit, it will____________?
A. run faster
B. spark at light loads
C. draw excessive current and overheat
D. run slower - The running winding of a single phase motor on testing with meggar is found to be ground. Most probable location of the ground will be___________?
A. at the end connections
B. at the end terminals
C. anywhere on the winding inside a slot
D. at the slot edge where coil enters or comes out of the slot - In A.C. series motor compensating winding is employed to_____________?
A. reduce the effects of armature reaction
B. increase the torque
C. reduce sparking at the brushes
D. none of the above
