A. using focusing collector or heliostates
B. using flat plate collectors
C. using a solar pond
D. any of the above system
Related Mcqs:
- At low value of power factor, the cost of generation of a power station will be____________?
A. high
B. low
C. remain same
D. none of the above - If the load factor of a power station is high then its cost of generation will be_______?
A. High.
B. Low.
C. Remain same.
D. Depend upon plant type. - If the diversity factor of a power station is high then its generation cost is___________?
A. high
B. low
C. remain same
D. depend on the plan type - The overall efficiency of thermal power plant is equal to____________?
A. Rankine cycle efficiency
B. Carnot cycle efficiency
C. Regenerative cycle efficiency
D. Boiler efficiency x turbine efficiency x generator efficiency - In thermal power plant, heat from the flue gases is utilized in___________?
A. super heater
B. condenser
C. economizer
D. chimney - The overall efficiency of a steam power station is ________ its thermal efficiency.
A. less than
B. equal to
C. greater than
D. none of the above - Which material is used to made a solar cell_______________?
A. aluminum
B. Germanium
C. silicon
D. scandium - The voltage of a single solar cells is about
A. 0.5 volt
B. 1 volt
C. 1.8 volt
D. 1. 5 volt - The maximum percentage gain in Regenerative feed heating cycle thermal efficiency____________?
A. increases with number of feed heaters increasing
B. decreases with number of feed heaters increasing
C. remains same unaffected by number of feed heaters
D. none of the above - The thermal efficiency of the engine with condenser as compared to without condenser, for a given pressure and temperature of steam, is_____________?
A. higher
B. lower
C. same as long as initial pressure and temperature is unchanged
D. none of the above