A. reduce the flame length
B. increase the flame length
C. transport and dry the coal
D. provide air round the burners for getting optimum combustion
Related Mcqs:
- Primary air is that air which is used to_____________?
A. reduce the flame length
B. increase the flame length
C. transport and dry the coal
D. provide air around burners for get¬ting optimum combustion - The percentage O2 by Weight in atmospheric air is____________?
A. 18%
B. 23%
C. 77%
D. 79% - The percentage 02 by volume in atmosphere air is____________?
A. 21%
B. 23%
C. 77%
D. 79% - Edward’s air pump____________?
A. removes air and also vapour from condenser
B. removes only air from condenser
C. removes only un-condensed vapour from condenser
D. removes air alongwith vapour and also the condensed water from condenser - In a surface condenser if air is removed, there is___________?
A. fall in absolute pressure maintained in condenser
B. rise in absolute pressure maintained in condenser
C. no change in absolute pressure in the condenser
D. rise in temperature of condensed steam - The amount of air which is supplied for complete combustion is called___________?
A. primary air
B. secondary air
C. tertiary air - The overall efficiency of thermal power plant is equal to____________?
A. Rankine cycle efficiency
B. Carnot cycle efficiency
C. Regenerative cycle efficiency
D. Boiler efficiency x turbine efficiency x generator efficiency - In a boiler installation the natural draught is produced_____________?
A. due to the fact that furnace gases being light go through the chimney giving place to cold air from outside to rush in
B. due to the fact that pressure at the grate due to cold column is higher than the pressure at the chimney base due to hot column
C. due to the fact that at the chimney top the pressure is more than its environmental pressure
D. all of the above - The ratio of exit pressure to inlet pressure for maximum mass flow rate per unit area of steam through a nozzle when steam is initially dry saturated is___________?
A. 0.6
B. 0.578
C. 0.555
D. 0.5457 - Reheat factor is the ratio of_____________?
A. isentropic heat drop to useful heat drop
B. adiabatic heat drop to isentropic heat drop
C. cumulative actual enthalpy drop for the stages to total is isentropic enthalpy heat drop