A. Current transformer
B. Potential transformer
C. Power transformer
D. SCR
Related Mcqs:
- A single phase full bridge inverter can operated in load commutation mode in case load consist of______?
A. RL.
B. RLC underdamped.
C. RLC overdamped.
D. RLC critically damped - A single phase full bridge inverter can operate in load commutation mode in case load consists of____________?
A. RL.
B. RLC underdamped.
C. RLC overdamped.
D. RLC critically damped. - In a 3 phase bridge rectifier the ripple frequency is _____________?
A. Equal to the input frequency
B. Twice the input frequency
C. Three times the input frequency
D. Six times the input frequency - The advantage of using free – wheeling diode in half controlled bridge converter is that
A. There is always a path for the dc current independent of the ac line
B. There is always a path for the ac current independent of the ac line
C. There is always a path for the dc current dependent of the ac line
D. There is always a path for the ac current independent of the ac line - The input current waveform of a bridge controlled rectifier when the load is perfectly filtered is___________?
A. Sine wave
B. Square wave
C. Saw – tooth wave
D. Trapezoidal wave - In a full bridge VSI, in order to avoid the short circuit across the DC bus and the undefined AC output voltage condition, the modulating technique should ensure that___________?
A. Top switch of each leg is on at any instant
B. Bottom switch of each leg is on at any instant
C. Either A. or B.
D. None of these - A Triac is a ______________?
A. 2 terminal switch
B. 2 terminal bilateral switch
C. 3 terminal bilateral switch
D. 3 terminal bidirectional switch - Form factor of a rectifier is the ratio of ______________?
A. Root mean square value of voltage and current to its peak value
B. Root mean square value of voltage and current to its average value
C. Average value of current and voltage to its root mean square value
D. Peak value of current and voltage to its root mean square value - The typical value of SCR for modern alternator is____________?
A. 1.5.
B. 0.5.
C. 1.0.
D. 1.2. - BCT is used for____________?
A. High power phase control
B. High power current control
C. Low power current control
D. Low power phase control
