A. The slip of the motor will be 5%
B. The rotor will not run
C. The rotor will run at very high speed
D. The torque produced will be very large
Related Mcqs:
- If an induction motor with certain ratio of rotor to stator slots, runs at 1/7 of the normal speed, the phenomenon will be termed as____________?
A. humming
B. hunting
C. crawling
D. cogging - In an induction motor the relationship between stator slots and rotor slots is that_____________?
A. stator slots are equal to rotor slots
B. stator slots are exact multiple of rotor slots
C. stator slots are not exact multiple of rotor slots
D. none of the above - If a 3-phase supply is given to the stator and rotor is short circuited rotor will move___________?
A. in the opposite direction as the direction of the rotating field
B. in the same direction as the direction of the field
C. in any direction depending upon phase squence of supply - A 3-phase induction motor stator delta connected, is carrying full load and one of its fuses blows out. Then the motor_______________?
A. will continue running burning its one phase
B. will continue running burning its two phases
C. will stop and carry heavy current causing permanent damage to its winding
D. will continue running without any harm to the winding - Temperature of the stator winding of a three phase induction motor is obtained by___________?
A. resistance rise method
B. thermometer method
C. embedded temperature method
D. all above methods - A pump induction motor is switched on to a supply 30% lower than its rated voltage. The pump runs. What will eventually happen ? It will____________?
A. stall after sometime
B. stall immediately
C. continue to run at lower speed without damage
D. get heated and subsequently get damaged - In Ns is the synchronous speed and s the slip, then actual running speed of an induction motor will be___________?
A. Ns
B. s.N,
C. (l-s)Ns
D. (Ns-l)s - A 3-phase 440 V, 50 Hz induction motor has 4% slip. The frequency of rotor e.m.f. will be____________?
A. 200 Hz
B. 50 Hz
C. 2 Hz
D. 0.2 Hz - In the squirrel-cage induction motor the rotor slots are usually given slight skew__________?
A. to reduce the magnetic hum and locking tendency of the rotor
B. to increase the tensile strength of the rotor bars
C. to ensure easy fabrication
D. none of the above - The torque of a rotor in an induction motor under running condition is maximum__________?
A. at the unit value of slip
B. at the zero value of slip
C. at the value of the slip which makes rotor reactance per phase equal to the resistance per phase
D. at the value of the slip which makes the rotor reactance half of the rotor
