The good power factor of an induction motor can be achieved if the average flux density in the air gap is___________?

Related Mcqs:

1. In case the air gap in an induction motor is increased?

   A. the magnetising current of the rotor will decrease B. the power factor will decrease C. speed of motor will increase D. the windage losses will increase...

2. In case the air gap in an induction motor is increased____________?

   A. the magnetising current of the rotor will decrease B. the power factor will decrease C. speed of motor will increase D. the windage losses will increase...

3. In an induction motor if air-gap is increased__________?

   A. the power factor will be low B. windage losses will be more C. bearing friction will reduce D. copper loss will reduce In an induction motor...

4. The power factor of an induction motor under no-load conditions will be closer to_____________?

   A. 0.2 lagging B. 0.2 leading C. 0.5 leading D. unity...

5. The low power factor of induction motor is due to___________?

   A. rotor leakage reactance B. stator reactance C. the reactive lagging magnetizing current necessary to generate the magnetic flux D. all of the above...

6. What will happen if the relative speed between the rotating flux of stator and rotor of the induction motor is zero ?

   A. The slip of the motor will be 5% B. The rotor will not run C. The rotor will run at very high speed D. The torque produced will be very large...

7. The torque of an induction motor is___________?

   A. directly proportional to slip B. inversely proportional to slip C. proportional to the square of the slip D. none of the above...

8. The starting torque of a squirrel-cage induction motor is___________?

   A. low B. negligible C. same as full-load torque D. slightly more than full-load torque...

9. The torque developed in the cage induction motor with autostarter is___________?

   A. k/torque with direct switching B. K x torque with direct switching C. K2 x torque with direct switching D. k2/torque with direct switching...

10. Slip ring motor is preferred over squirrel cage induction motor where___________?

    A. high starting torque is required B. load torque is heavy C. heavy pull out torque is required D. all of the above...