A. self-starting with zero torque
B. self-starting with high torque
C. self-starting with low torque
D. non-self starting
Related Mcqs:
- The shape of the torque/slip curve of induction motor is__________?
A. parabola
B. hyperbola
C. rectangular parabola
D. straigth line - Slip ring motor is preferred over squirrel cage induction motor where___________?
A. high starting torque is required
B. load torque is heavy
C. heavy pull out torque is required
D. all of the above - The efficiency of an induction motor can be expected to be nearly____________?
A. 60 to 90%
B. 80 to 90%
C. 95 to 98%
D. 99% - The injected e.m.f. in the rotor of induction motor must have__________?
A. zero frequency
B. the same frequency as the slip frequency
C. the same phase as the rotor e.m.f.
D. high value for the satisfactory speed control - In a three-phase induction motor, the number of poles in the rotor winding is always__________?
A. zero
B. more than the number of poles in stator
C. less than number of poles in stator
D. equal to number of poles in stator - If an induction motor with certain ratio of rotor to stator slots, runs at 1/7 of the normal speed, the phenomenon will be termed as____________?
A. humming
B. hunting
C. crawling
D. cogging - A pump induction motor is switched on to a supply 30% lower than its rated voltage. The pump runs. What will eventually happen ? It will____________?
A. stall after sometime
B. stall immediately
C. continue to run at lower speed without damage
D. get heated and subsequently get damaged - A 500 kW, 3-phase, 440 volts, 50 Hz, A.C. induction motor has a speed of 960 r.p.m. on full load. The machine has 6 poles. The slip of the machine will be__________?
A. 0.01
B. 0.02
C. 0.03
D. 0.04 - What will happen if the relative speed between the rotating flux of stator and rotor of the induction motor is zero ?
A. The slip of the motor will be 5%
B. The rotor will not run
C. The rotor will run at very high speed
D. The torque produced will be very large - The starting torque of a three phase induction motor can be increased by__________?
A. increasing slip
B. increasing current
C. both A. and (b)
D. none of the above
