A. arc heating
B. resistance heating
C. induction heating
D. dielectric heating
Related Mcqs:
- In heating the ferromagnetic material by induction heating, heat is produced due to_____________?
A. induced current flow through the charge
B. hysteresis loss taking place below curie temperature
C. due to hysteresis loss as well as eddy current loss takingplace in the charge
D. none of the above factors - In the indirect resistance heating method, maximum heat-transfer takes place by____________?
A. radiation
B. convection
C. conduction
D. any of the above - In resistance heating highest working temperature is obtained from heating elements made of_____________?
A. nickel copper
B. nichrome
C. silicon carbide
D. silver - For radiant heating around 2250°C, the heating elements are made of____________?
A. copper alloy
B. carbon
C. tungsten alloy
D. stainless steel alloy - In electric press, mica is used because it is _________ conductor of heat but/and __________ conductor of electricity?
A. bad, good
B. bad, bad
C. good, bad
D. good, good - Which of the following methods of heating is not dependent on the frequency of supply ?
A. Induction heating
B. Dielectric heating
C. Electric resistance heating
D. All of the above - Which of the following is an advantage of heating by electricity ?
A. Quicker operation
B. Higher efficiency
C. Absence of flue gases
D. All of the above - Which of the following heating methods has maximum power factor ?
A. Arc heating
B. Dielectric heating
C. Induction heating
D. Resistance heating - In induction heating ___________ is abnormally high?
A. phase angle
B. frequency
C. current
D. voltage - For heating element high resistivity material is chosen to______________?
A. reduce the length of heating element
B. increase the life of the heating element
C. reduce the effect of oxidation
D. produce large amount of heat
