A. using vent plug to permit gas formed during discharge
B. increasing the plate area
C. putting plates very close together
D. all above methods
Related Mcqs:
- The internal resistance of an alkali cell is nearly _________ times that of the lead-acid cell
A. two
B. three
C. four
D. five - When the specific gravity of the electrolyte of a lead-acid cell is reduced to 1.1 to 1.15 the cell is in___________?
A. charged state
B. discharged state
C. both (A) and (B)
D. active state - The internal resistance of a lead-acid cell is that of Edison cell____________?
A. less than
B. more than
C. equal to
D. none of the above - Internal resistance of a cell is due to___________?
A. resistance of electrolyte
B. electrode resistance
C. surface contact resistance between electrode and electrolyte
D. all above - When the load resistance equals the generator resistance which of the following will be maximum __________?
A. Current
B. Efficiency of the circuit
C. Power in the load resistance
D. Voltage across the load resistance - As compared to a lead-acid cell, the efficiency of a nickel-iron cell is less due to its__________?
A. compactness
B. lower e.m.f.
C. small quantity of electrolyte used
D. higher internal resistance - Self charge of a Ni-Fe cell is _______ Edison cell
A. equal to
B. less than
C. more than
D. much more than - Internal short circuits are caused by___________?
A. breakdown of one or more separators
B. excess accumulation of sediment at the bottom of the cell
C. both (A) and (B)
D. none of the above - The effect of sulphation is that the internal resistance__________?
A. increases
B. decreases
C. remains same
D. none of the above - Battery container should be acid resistance, therefore it is made up of___________?
A. glass
B. plastic
C. wood
D. all above
