A. Two electrodes of different meta’s should be inserted in the electrolyte, not touching each other
B. Electrolyte must chemically react with one of the electrodes
C. Electrolyte liquid or paste should be conducting
D. All above three conditions are necessary
Related Mcqs:
- As compared to a lead-acid cell, the efficiency of a nickel-iron cell is less due to its__________?
A. compactness
B. lower e.m.f.
C. small quantity of electrolyte used
D. higher internal resistance - The internal resistance of an alkali cell is nearly _________ times that of the lead-acid cell
A. two
B. three
C. four
D. five - When the specific gravity of the electrolyte of a lead-acid cell is reduced to 1.1 to 1.15 the cell is in___________?
A. charged state
B. discharged state
C. both (A) and (B)
D. active state - Self charge of a Ni-Fe cell is _______ Edison cell
A. equal to
B. less than
C. more than
D. much more than - Which of the following cell has a. reversible chemical reaction ___________?
A. Lead-acid
B. Mercury oxide
C. Carbon-zinc
D. Silver-oxide - When a lead-acid battery is in fully charged condition, the color of its positive plate is__________?
A. dark grey
B. brown
C. dark brown
D. none of above - In a lead-acid cell, if the specific gravity of sulphuric acid is 1.8, it will require following ratio of acid to water to get mixture of specific gravity of 1.3
A. 6 parts of acid to 4 parts of water
B. 4 parts of acid to 4 parts of water
C. 4 parts of acid to 6 parts of water
D. 4 parts of acid to 8 parts of water - If a lead-acid cell is discharged below 1.8 V the following will happen.____________?
A. Capacity of cell will reduce
B. Sulphation of plates will occur
C. Internal resistance will increase
D. All above will occur - Mercury cell has which of the following characteristics ____________?
A. Flat discharge current-voltage curve
B. High power to weight ratio
C. Comparatively longer shelf life under adverse conditions of high temperature and humidity
D. All of the above - Short circuiting of a cell may be caused____________?
A. buckling of plates
B. faulty separators
C. lead particles forming circuit between positive and negative plates
D. excessive accumulation of sediment
E. any one of above
