A. plant is used for stand by purpose only
B. plant is under maintenance
C. plant is used for base load only
D. plant is used for peak load as well as base load
Related Mcqs:
- Power plant having maximum demand more than the installed rated capacity will have utilization factor?
A. equal to unity
B. less than unity
C. more than unity
D. none of the above - In a power plant if the maximum demand on the plant is equal to the plant capacity, then
A. plant reserve capacity will be zero
B. diversity factor will be unity
C. load factor will be unity
D. load factor will be nearly 60% - High load factor indicates
A. average power used during the period
B. average kWh (kW) energy consumption during the period
C. either of the above
D. none of the above - The primary reason for low power factor is supply system is due to installation of____________?
A. induction motors
B. synchronous motors
C. single phase motors
D. d.c. motors - Low power factor is usually not due to___________?
A. arc lamps
B. induction motors
C. fluorescent tubes
D. incandescent lamp - Which of the following is the disadvantage due to low power factor?
A. Poor voltage regulation
B. Increased transmission losses
C. High cost of equipment for a given load
D. All of the above - Which plant can never have 100 percent load factor?
A. Peak load plant
B. Base load plant
C. Nuclear power plant
D. Hydro electric plant - Annual depreciation of the plant it proportional to the earning capacity of the plant vide
A. sinking fund depreciation
B. straight line depreciation
C. reducing balances depreciation
D. none of the above - Load factor of a power station is generally___________?
A. equal to unity
B. less than unity
C. more than unity
D. equal to zero Diversity factor is always - In an interconnected system, the diversity factor of the whole system:
A. remains unchanged
B. decreases
C. increases
D. none of the above
