A. Series generator
B. Shunt generator
C. Over compound generator
D. Flat compound generator
Related Mcqs:
- Two generators A and B have 6-poles each. Generator A has wave wound armature while generator B has lap wound armature. The ratio of the induced e.m.f. is generator A and B will be_______________?
A. 2 : 3
B. 3 : 1
C. 3 : 2
D. 1 : 3 - Which of the following components of a D.C, generator plays vital role for providing direct current of a D.C. generator ?
A. Dummy coils
B. Commutator
C. Eye bolt
D. Equilizer rings - The e.m.f. generated by a shunt wound D.C. generator isE. Now while pole flux remains constant, if the speed of the generator is doubled, the e.m.f. generated will be_______________?
A. E/2
B. 2E
C. slightly less than E
D. E - If brushes of a D.C. generator are moved in order to bring these brushes in magnetic neutral axis, there will be________________?
A. demagnetisation only
B. cross magnetisation as well as mag¬netisation
C. crossmagnetisation as well as demagnetising
D. cross magnetisation only - To achieve sparkless commutation brushes of a D.C. generator are rockedm ahead so as to bring them?
A. just ahead of magnetic neutral axis
B. in magnetic neutral axis
C. just behind the magnetic neutral axis
D. none - A D.C. generator can be considered as____________?
A. rectifier
B. primemover
C. rotating amplifier
D. power pump - In over compounded generator, full load terminal voltage is______________?
A. almost zero
B. less than no load terminal voltage
C. more than no load terminal voltage
D. equal to no-load terminal voltage - In a separately excited generator supplying rated load the armature reaction.
A. is always present
B. is always absent
C. may be sometimes present
D. none of the above - The number of armature parallel paths in a two-pole D.C. generator having duplex lap winding is______________?
A. 2
B. 4
C. 6
D. 8 - If a self excited D.C. generator after being installed, fails to build up on its first trial run, the first thing to do is to______________?
A. reverse the field connections
B. increase the field resistance
C. increase the speed of primemover
D. check armature insulation resistance
