A. length of conductor
B. cross-sectional area of the conductor
C. number of conductors
D. all of the above
Related Mcqs:
- The e.m.f. induced in the armature of a shunt generator is 600 V. The armature resistance is 0.1 ohm. If the armature current is 200 A, the terminal voltage will be_____________?
A. 640 V
B. 620 V
C. 600 V
D. 580 V - Two D.C. shunt generators, each with armature resistance of 0.02 ohm and field resistance of 50 ohm run in parallel and supply a total current of 1000 amperes to the load circuit. If their e.m.fs. are 270 V and 265 V, their bus bar voltage will be_____________________?
A. 270 V
B. 267.5 V
C. 265 V
D. 257.4 V - Two generators A and B have 6-poles each. Generator A has wave wound armature while generator B has lap wound armature. The ratio of the induced e.m.f. is generator A and B will be_______________?
A. 2 : 3
B. 3 : 1
C. 3 : 2
D. 1 : 3 - For a D.C. generator when the number of poles and the number of armature conductors is fixed, then which winding will give the higher e.m.f___________ ?
A. Lap winding
B. Wave winding
C. Either of A. and B. above
D. Depends on other features of design - The following constitute short-circuit in the armature winding.
A. Insulation failure between two commutator bars
B. Insulation failure between two turns of a coil
C. Two of more turns of the same coil getting grounded
D. All of the above - The number of armature parallel paths in a two-pole D.C. generator having duplex lap winding is______________?
A. 2
B. 4
C. 6
D. 8 - In a D.C. generator in case the resistance of the field winding is increased, then output voltage will____________?
A. increase
B. decrease
C. remain unaffected
D. fluctuate heavily - In a D.C. generator the critical resistance refers to the resistance of_____________?
A. brushes
B. field
C. armature
D. load - The critical resistance of the D.C. generator is the resistance of_____________?
A. field
B. brushes
C. armature
D. load - Armature reaction of an unsaturated D.C. machine is_____________?
A. crossmagnetising
B. demagnetising
C. magnetising
D. none of above