A. zero
B. small
C. the same as rated voltage
D. high
Related Mcqs:
- Two generators A and B have 6-poles each. Generator A has wave wound armature while generator B has lap wound armature. The ratio of the induced e.m.f. is generator A and B will be_______________?
A. 2 : 3
B. 3 : 1
C. 3 : 2
D. 1 : 3 - Following D.C. generator will be in a position to build up without any residual magnetism in the poles______________?
A. series generator
B. shunt generator
C. compound generator
D. self-excited generator - Which of the following D.C. generators will be in a position to build up without any residual magnetism in the poles?
A. Series generator
B. Shunt generator
C. Compound generator
D. None of the above - The e.m.f. generated by a shunt wound D.C. generator isE. Now while pole flux remains constant, if the speed of the generator is doubled, the e.m.f. generated will be_______________?
A. E/2
B. 2E
C. slightly less than E
D. E - A cumulatively compounded long shunt generator when operating as a motor would be____________?
A. cumulatively compounded long shunt
B. deferentially compounded long shunt
C. cumulatively compounded short shunt
D. differentially compounded short shunt - The terminal voltage of a series generator is 150 V when the load current is 5 A. If the load current is increased to 10 A, the terminal voltage will be____________?
A. 150 V
B. less than 150 V
C. greater than 150 V
D. none of the above - Which of the following components of a D.C, generator plays vital role for providing direct current of a D.C. generator ?
A. Dummy coils
B. Commutator
C. Eye bolt
D. Equilizer rings - The e.m.f. induced in the armature of a shunt generator is 600 V. The armature resistance is 0.1 ohm. If the armature current is 200 A, the terminal voltage will be_____________?
A. 640 V
B. 620 V
C. 600 V
D. 580 V - In a D.C. generator in order to reduce sparking at brushes, the self-induced e.m.f. in the coil is neutralised by all of the following except______________?
A. interpoles
B. dummy coils
C. compensating winding
D. shifting of axis of brushes - According to Fleming’s right-hand rule for finding the direction of induced e.m.f., when middle finger points in the direction of induced e.m.f., forefinger will point in the direction of____________?
A. motion of conductor
B. lines of force
C. either of the above
D. none of the above