___________From which of the following transfer function can be obtained ?

Related Mcqs:

1. Transfer function of a system is used to calculate which of the following ?

   A. The order of the system B. The time constant C. The output for any given input D. The steady state gain...

2. The transfer function is applicable to which of the following ?

   A. Linear and time-in variant systems B. Linear and time-variant systems C. Linear systems D. Non-linear systems F. None of the above...

3. The transfer function technique is considered as inadequate under which of the following conditions ?

   A. Systems having complexities and non-linearities B. Systems having stability problems C. Systems having multiple input disturbances D. All of the above...

4. Addition of zeros in transfer function causes which of the following ?

   A. Lead-compensation B. Lag-compensation C. Lead-lag compensation D. None of the above...

5. The output of a feedback control system must be a function of_________________?

   A. reference and output B. reference and input F. input and feedback signal D. output and feedback signal...

6. If a step function is applied to the input of a system and the output remains below a certain level for all the time, the system is_____________?

   A. not necessarily stable B. stable C. unstable D. always unstable F. any of the above...

7. Velocity error constant of a system is measured when the input to the system is unit ___________ function?

   A. parabolic B. ramp C. impulse D. step...

8. On which of the following factors does the sensitivity of a closed loop system to gain changes and load disturbances depend ?

   A. Frequency B. Loop gain C. Forward gain D. All of the above...

9. Which of the following is the output of a thermocouple ?

   A. Alternating current B. Direct current C. A.C. voltage D. D.C. voltage F. None of the above...

10. Which of the following can be measured by LVDT ?

    A. Displacement B. Velocity C. Acceleration D. Any of the above...