A. Ramp input signal
B. Sinusoidal input signal
C. Unit impulse input signal
D. Exponentially decaying signal
Related Mcqs:
- Which of the following is the best method for determining the stability and transient response ?
A. Root locus
B. Bode plot
C. Nyquist plot
D. None of the above - The initial response when tne output is not equal to input is called_____________?
A. Transient response
B. Error response
C. Dynamic response
D. Either of the above - The transient response, with feedback system_____________?
A. rises slowly
B. rises quickly
C. decays slowly
D. decays quickly - The transient response of a system is mainly due to________________?
A. inertia forces
B. internal forces
C. stored energy
D. friction - Which of the following devices are commonly used as error detectors in instruments ?
A. Vernistats
B. Microsyns
C. Resolvers
D. Any of the above - On which of the following factors does the sensitivity of a closed loop system to gain changes and load disturbances depend ?
A. Frequency
B. Loop gain
C. Forward gain
D. All of the above - Due to which of the following reasons excessive bond width in control systems should be avoided ?
A. It leads to slow speed of response
B. It leads to low relative stability
C. Noise is proportional to band width
D. None of the above - Which of the following is the output of a thermocouple ?
A. Alternating current
B. Direct current
C. A.C. voltage
D. D.C. voltage
F. None of the above - Which of the following can be measured by the use of a tachogenerator ?
A. Acceleration
B. Speed
C. Speed and acceleration
D. Displacement
F. None of the above - Which of the following can be measured by LVDT ?
A. Displacement
B. Velocity
C. Acceleration
D. Any of the above
