A. 23dB
B. 25dB
C. 46dB
D. 50dB
Related Mcqs:
- A differential amplifier has a differential gain of 20,000 . CMRR=80 dB. The common mode gain is given by________?
A. 2
B. 1
C. 1/2
D. 0 - An amplifier without feedback has a voltage gain of 50,input resistance os 1 KΩ & Output resistance of 2.5KΩ.The input resistance of the current-shunt negative feedback amplifier using the above amplifier with a feedback factor of 0.2 is___________?
A. 1/11KΩ
B. 1/5KΩ
C. 5KΩ
D. 11KΩ - Three identical amplifiers with each one having a voltage gain of 50,input resistance of 1KΩ & output resistance of 250 ,are cascaded.The open circuit voltage gain of combined amplifier is_________?
A. 49dB
B. 51dB
C. 98dB
D. 102dB - A 741-type OP-AMP has a gain-bandwidth product of 1MHz. A non-inverting amplifier using this op-amp & having a voltage gain of 20db will exhibit -3db bandwidth of__________?
A. 50 KHz
B. 100KHz
C. 1000/17 KHz
D. 1000/7.07 KHz - An amplifier using an opamp with slew rate SR=1v/µsec has a gain of 40db.if this amplifier has to faithfully amplify sinusoidal signals from dc to 20 KHz without introducing any slew-rate induced distortion, then the input signal level must not exceed________?
A. 795mV
B. 395mV
C. 795 mV
D. 39.5mV - A dc power supply has no-load voltage of 30v,and a full-load voltage of 25v at full-load current of 1A.Its output resistance & load regulation ,respectively are_____________?
A. 5 Ω & 20 %
B. 25 Ω & 20 %
C. 5 Ω & 16.7 %
D. 25 Ω & 16.7 % - In a full-wave rectifier using two ideal diodes,Vdc & Vm are the dc & peak values of the voltage respectively across a resistive load. If PIV is the peak inverse voltage of the diode, then the appropriate relationships for this rectifier is____________?
A. Vdc = Vm/π, PIV=2Vm
B. Vdc = 2Vm/π, PIV=2vm
C. Vdc = 2Vm/π, PIV=Vm
D. Vdc = Vm/π, PIV=Vm - A change in the value of the emitter resistance Re in a differential amplifier?
A. affects the difference mode gain Ad
B. affects the common mode gain Ac
C.affects both Ad and Ac
D. does not effect either Ad and Ac - Most of the linear ICs are based on the two-transistor differential amplifier because of its___________?
A. input voltage dependent linear transfer characteristic
B. high voltage gain
C. high input resistance
D. high CMRR - A differential amplifier is invariably used in the i/p stage of all OP-amps. This is done basically to provide the OP-amps with a very high_________?
A. CMMR
B. Bandwidth
C. Slew rate
D. Open-loop gain