A differential amplifier is invariably used in the i/p stage of all OP-amps. This is done basically to provide the OP-amps with a very high_________?

Related Mcqs:

1. In the differential voltage gain & the common mode voltage gain of a differential amplifier are 48db &2db respectively, then its common mode rejection ratio is__________?

   A. 23dB B. 25dB C. 46dB D. 50dB...

2. A differential amplifier has a differential gain of 20,000 . CMRR=80 dB. The common mode gain is given by________?

   A. 2 B. 1 C. 1/2 D. 0...

3. An amplifier without feedback has a voltage gain of 50,input resistance os 1 KΩ & Output resistance of 2.5KΩ.The input resistance of the current-shunt negative feedback amplifier using the above amplifier with a feedback factor of 0.2 is___________?

   A. 1/11KΩ B. 1/5KΩ C. 5KΩ D. 11KΩ...

4. A change in the value of the emitter resistance Re in a differential amplifier?

   A. affects the difference mode gain Ad B. affects the common mode gain Ac C.affects both Ad and Ac D. does not effect either Ad and Ac...

5. Most of the linear ICs are based on the two-transistor differential amplifier because of its___________?

   A. input voltage dependent linear transfer characteristic B. high voltage gain C. high input resistance D. high CMRR...

6. An amplifier using an opamp with slew rate SR=1v/µsec has a gain of 40db.if this amplifier has to faithfully amplify sinusoidal signals from dc to 20 KHz without introducing any slew-rate induced distortion, then the input signal level must not exceed________?

   A. 795mV B. 395mV C. 795 mV D. 39.5mV...

7. A 741-type OP-AMP has a gain-bandwidth product of 1MHz. A non-inverting amplifier using this op-amp & having a voltage gain of 20db will exhibit -3db bandwidth of__________?

   A. 50 KHz B. 100KHz C. 1000/17 KHz D. 1000/7.07 KHz...

8. Three identical amplifiers with each one having a voltage gain of 50,input resistance of 1KΩ & output resistance of 250 ,are cascaded.The open circuit voltage gain of combined amplifier is_________?

   A. 49dB B. 51dB C. 98dB D. 102dB...

9. The most commonly used amplifier in sample & hold circuits is______________?

   A. A unity gain non-inverting amplifier B. A unity gain inverting amplifier C. An inverting amplifier with a gain of 10 D. An inverting amplifiers with a gain of 100...

10. The cascade amplifier is a multistage configuration of__________?

    A. CC-CB . B. CE-CB C. CB-CC D. CE-CC...