Related Mcqs:

1. An amplifier without feedback has a voltage gain of 50,input resistance os 1 KΩ & Output resistance of 2.5KΩ.The input resistance of the current-shunt negative feedback amplifier using the above amplifier with a feedback factor of 0.2 is___________?

   A. 1/11KΩ
   B. 1/5KΩ
   C. 5KΩ
   D. 11KΩ

2. In a full-wave rectifier using two ideal diodes,Vdc & Vm are the dc & peak values of the voltage respectively across a resistive load. If PIV is the peak inverse voltage of the diode, then the appropriate relationships for this rectifier is____________?

   A. Vdc = Vm/π, PIV=2Vm
   B. Vdc = 2Vm/π, PIV=2vm
   C. Vdc = 2Vm/π, PIV=Vm
   D. Vdc = Vm/π, PIV=Vm

3. Three identical amplifiers with each one having a voltage gain of 50,input resistance of 1KΩ & output resistance of 250 ,are cascaded.The open circuit voltage gain of combined amplifier is_________?

   A. 49dB
   B. 51dB
   C. 98dB
   D. 102dB

4. In the differential voltage gain & the common mode voltage gain of a differential amplifier are 48db &2db respectively, then its common mode rejection ratio is__________?

   A. 23dB
   B. 25dB
   C. 46dB
   D. 50dB

5. An OPAMP has a slew rate of 5 V/μ S .The largest sine wave O/P voltage possible at a frequency of 1 MHZ is [Hint: Slew rate is defined as the max. rate of change of output voltage. Its unit is V/μS.

   A. 10 volts
   B. 5 volts
   C. 5/1 volts
   D. 5/2 volts

6. A constant current signal across a parallel RLC circuits gives an o/p of 1.4v at the signal frequency of 3.89KHZ and 4.1KHZ .At the frequency of 4KHZ,the o/p voltage will be___________?

   A. 1 v
   B. 2v
   C. 1.4v
   D. 2.8v

7. An n- channel JFET has IDSS=2mA,and Vp=-4v.Its transconductance gm=in mA/V)for an applied gate to source voltage VGS=-2v is___________?

   A. 0.25
   B. 0.5
   C. 0.75
   D. 1

8. A 741-type OP-AMP has a gain-bandwidth product of 1MHz. A non-inverting amplifier using this op-amp & having a voltage gain of 20db will exhibit -3db bandwidth of__________?

   A. 50 KHz
   B. 100KHz
   C. 1000/17 KHz
   D. 1000/7.07 KHz

9. Voltage Series feedback also called series-shunt feedback) results in__________?

   A. Increase in both input & output impedances
   B. Decreases in both input & output impedances
   C. Increase in input impedance & decreases in output impedance
   D. Decrease in input impedance & increase in output impedance

10. A source follower using an FET usually has a voltage gain which is___________?

    A. greater than +100
    B. slightly less than unity but positive
    C. exactly unity but negative
    D. about -10