A. 1 v
B. 2v
C. 1.4v
D. 2.8v
Advertisement
Related Mcqs:
- An OPAMP has a slew rate of 5 V/μ S .The largest sine wave O/P voltage possible at a frequency of 1 MHZ is [Hint: Slew rate is defined as the max. rate of change of output voltage. Its unit is V/μS.
- A. 10 volts B. 5 volts C. 5/1 volts D. 5/2 volts...
- In a full-wave rectifier using two ideal diodes,Vdc & Vm are the dc & peak values of the voltage respectively across a resistive load. If PIV is the peak inverse voltage of the diode, then the appropriate relationships for this rectifier is____________?
- A. Vdc = Vm/π, PIV=2Vm B. Vdc = 2Vm/π, PIV=2vm C. Vdc = 2Vm/π, PIV=Vm D. Vdc = Vm/π, PIV=Vm...
- A dc power supply has no-load voltage of 30v,and a full-load voltage of 25v at full-load current of 1A.Its output resistance & load regulation ,respectively are_____________?
- A. 5 Ω & 20 % B. 25 Ω & 20 % C. 5 Ω & 16.7 % D. 25 Ω & 16.7 %...
- The most commonly used amplifier in sample & hold circuits is______________?
- A. A unity gain non-inverting amplifier B. A unity gain inverting amplifier C. An inverting amplifier with a gain of 10 D. An inverting amplifiers with a gain of 100...
- In the differential voltage gain & the common mode voltage gain of a differential amplifier are 48db &2db respectively, then its common mode rejection ratio is__________?
- A. 23dB B. 25dB C. 46dB D. 50dB...
- Three identical amplifiers with each one having a voltage gain of 50,input resistance of 1KΩ & output resistance of 250 ,are cascaded.The open circuit voltage gain of combined amplifier is_________?
- A. 49dB B. 51dB C. 98dB D. 102dB...
- Class AB operation is often used in power large signal amplifiers in order to_________?
- A. get maximum efficiency B. remove even harmonics C. overcome a crossover distortion D. reducing collector dissipation...
- An amplifier using an opamp with slew rate SR=1v/µsec has a gain of 40db.if this amplifier has to faithfully amplify sinusoidal signals from dc to 20 KHz without introducing any slew-rate induced distortion, then the input signal level must not exceed________?
- A. 795mV B. 395mV C. 795 mV D. 39.5mV...
- An amplifier without feedback has a voltage gain of 50,input resistance os 1 KΩ & Output resistance of 2.5KΩ.The input resistance of the current-shunt negative feedback amplifier using the above amplifier with a feedback factor of 0.2 is___________?
- A. 1/11KΩ B. 1/5KΩ C. 5KΩ D. 11KΩ...
- Voltage Series feedback also called series-shunt feedback) results in__________?
- A. Increase in both input & output impedances B. Decreases in both input & output impedances C. Increase in input impedance & decreases in output impedance D. Decrease in input impedance & increase in output impedance...
Advertisement