If the length of an intermediate span of a continuous slab is 5m, the length of the end span is kept_______________?

Related Mcqs:

1. For a continuous floor slab supported on beams, the ratio of end span length and intermediate span length, is____________________?

   A. 0.6
   B. 0.7
   C. 0.8
   D. 0.9

2. If K is a constant depending upon the ratio of the width of the slab to its effective span l, x is the distance of the concentrated load from the nearer support, bw is the width of the area of contact of the concentrated load measured parallel to the supported edge, the effective width of the slab be is_______________?

   A. K/x (1 + x/d) + bw
   B. Kx (1 – x/l) + bw
   C. Kx (1 + x/l) + bw
   D. All the above

3. If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than________________?

   A. WL/12 (L – 2D/3)²
   B. WL/10 (L + 2D/3)²
   C. WL/10 (L – 2D/3)²
   D. WL/12 (L – D/3)²

4. The floor slab of a building is supported on reinforced cement floor beams. The ratio of the end and intermediate spans is kept______________?

   A. 0.7
   B. 0.8
   C. 0.9
   D. 0.6

5. The ratio of the breadth to effective depth of a beam is kept_______________?

   A. 0.25
   B. 0.50
   C. 0.70
   D. 0.75

6. In case the factor of safety against sliding is less than 1.5, a portion of slab is constructed downwards at the end of the heel slab, which is known as___________________?

   A. A key
   B. A cut-off wall
   C. A rib
   D. All the above

7. Long and short spans of a two way slab are l and l and load on the slab acting on strips parallel to lx and ly be wx and wy respectively. Accordingy to xRankine Grashoff theory___________________?

   A. (wx/wy) = (ly/lx)
   B. (wx/wy) = (ly/lx)²
   C. (wx/wy) = (ly/lx)4
   D. None of these

8. on a circular slab of radius , the maximum radial moment at the centre of the If is the load slab, is WR²/16_____________?

   A. 2WR²/16
   B. 3WR²/16
   C. 5WR²/16
   D> NON OF THESE

9. An R.C.C. roof slab is designed as a two way slab if________________?

   A. It supports live loads in both directions
   B. The ratio of spans in two directions is less than 2
   C. The slab is continuous over two supports
   D. The slab is discontinuous at edges

10. bending moment of a simply supported slab is M Kg.cm, the effective depth of the If the maximum slab is (where Q is M.R. factor)________________?

    A. M/100Q
    B. M/ Q
    C. M/Q)
    D. (M/100Q)