A. 1
B. 2
C. 3
D. 5
Related Mcqs:
- If is the uniformly distributed load on a circular slab of radius maximum positive radial moment at its centre, is__________________?
A. 3WR²/16
B. 2WR²/16
C. WR²/16
D. None of these - on a circular slab of radius , the maximum radial moment at the centre of the If is the load slab, is WR²/16_____________?
A. 2WR²/16
B. 3WR²/16
C. 5WR²/16
D> NON OF THESE - If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than________________?
A. WL/12 (L – 2D/3)²
B. WL/10 (L + 2D/3)²
C. WL/10 (L – 2D/3)²
D. WL/12 (L – D/3)² - carrying a uniformly distributed load per metre length is suspended at the A pile of length centre and from other two points 0.15 L from either end ; the maximum hogging moment will be_______________?
A. WL²/15
B. WL²/30
C. WL²/60
D. WL²/90 - If W is the load on a circular slab of radius R, the maximum circumferential moment at the centre of the slab, is________________?
A. WR²/16
B. 2WR²/16
C. 3WR²/16
D. Zero - carrying a uniformly distributed load per metre length is suspended at two A pile of length points, the maximum, B.M. at the centre of the pile or at the points of suspension, is_________________?
A. WL/8
B. WL²/24
C. WL²/47
D. WL²/16 - If K is a constant depending upon the ratio of the width of the slab to its effective span l, x is the distance of the concentrated load from the nearer support, bw is the width of the area of contact of the concentrated load measured parallel to the supported edge, the effective width of the slab be is_______________?
A. K/x (1 + x/d) + bw
B. Kx (1 – x/l) + bw
C. Kx (1 + x/l) + bw
D. All the above - bending moment of a simply supported slab is M Kg.cm, the effective depth of the If the maximum slab is (where Q is M.R. factor)________________?
A. M/100Q
B. M/ Q
C. M/Q)
D. (M/100Q) - A simply supported beam 6 m long and of effective depth 50 cm, carries a uniformly distributed load 2400 kg/m including its self weight. If the lever arm factor is 0.85 and permissible tensile stress of steel is 1400 kg/cm2, the area of steel required, is___________________?
A. 14 cm 2
B. 15 cm2
C. 16 cm2
D. 17 cm2 - In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed________________?
A. 10 mm
B. 15 mm
C. 20 mm
D. 25 mm
