A. 0.5% and not more than 5% of cross-sectional area
B. 0.6% and not more than 6% of cross-sectional area
C. 0.7% and not more than 7% of cross-sectional area
D. 0.8% and not more than 8% of cross-sectional area
Related Mcqs:
- If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than________________?
A. WL/12 (L – 2D/3)²
B. WL/10 (L + 2D/3)²
C. WL/10 (L – 2D/3)²
D. WL/12 (L – D/3)² - Minimum spacing between horizontal parallel reinforcement of the same size should not be less than________________?
A. One diameter
B. 2.5 diameters
C. 3 diameters
D. 3.5 diameters - The diameter of transverse reinforcement of columns should be equal to one-fourth of the diameter of the main steel rods but not less than________________?
A. 4 mm
B. 5 mm
C. 6 mm
D. 7 mm - Minimum spacing between horizontal parallel reinforcement of different sizes, should not be less than________________?
A. One diameter of thinner bar
B. One diameter of thicker bar
C. Twice the diameter of thinner bar
D. None of these - If the length of a combined footing for two columns l metres apart is L and the projection on the left side of the exterior column is x, then the projection y on the right side of the exterior column, in order to have a uniformly distributed load, is (where is the distance of centre of gravity of column loads______________?
A. y = L – (l – ) )
B. y = L/2 + (l –
C. y = L/2 – (l + )
D. y = L/2 – (l – ) - An R.C.C. column is treated as short column if its slenderness ratio is less than_______________?
A. 30
B. 35
C. 40
D. 50 - The diameter of main bars in R.C.C. columns, shall not be less than________________?
A. 6 mm
B. 8 mm
C. 10 mm
D. 12 mm - According to I.S.: 456, 1978 the thickness of reinforced concrete footing on piles at its edges, is kept less than______________?
A. 5 cm
B. 10 cm
C. 15 cm
D. 20 cm - According to I.S. 456, 1978 the thickness of reinforced concrete footing on piles at its edges, is kept less than______________?
A. 20 cm
B. 30 cm
C. 40 cm
D. 75 cm - As per I.S. 456 – 1978, the pH value of water shall be_______________?
A. Less than 6
B. Equal to 6
C. Not less than 6
D. Equal to 7
