A. for points and crossings in the lead portion
B. with wooden sleepers at locations where creep is likely to be developed
C. on all joints and curves
D. on all the above
Related Mcqs:
- Anti creep bearing plates are provided on_________________?
A. bridges and approaches
B. joints
C. both (A) and (B)
D. none of the above - The type of bearing plate used in all joints and on curves to give better bearing area to the rails is___________________?
A. flat mild steel bearing plate
B. mild steel canted bearing plate
C. cast iron anti creep bearing plate
D. none of the above - To ensure exact gauge, the gauge tie plates are provided at_________________?
A. toe of the switch
B. nose of crossing
C. both (A) and (B)
D. none of the above - The cross-sectional area of 52 kg flat footed rail is_________________?
A. 6155 mm2
B. 6615 mm2
C. 7235 mm2
D. 7825 mm2 - Loose jaws of steel trough sleepers are made of___________________?
A. cast steel
B. mild steel
C. cast iron
D. spring steel - Tensile strength of steel used in rails should not be less than____________________?
A. 450 MPa
B. 500 MPa
C. 700 MPa
D. 850 MPa - Two important constituents in the com-position of steel used for rail are_________________?
A. carbon and silicon
B. manganese and phosphorous
C. carbon and manganese
D. carbon and sulfur - 52 kg rails are mostly used in__________________?
A. Broad Gauge
B. Meter Gauge
C. Narrow Gauge
D. both (A) and (B) - Consider the following statements about concrete sleepers_________________?
1. They improve the track modulus.
2. They have good scrap value.
3. They render transportation easy.
4. They maintain the gauge quite satisfactorily.Of these statementsA. 1 and 2 are correct
B. 2 and 3 are correct
C. 3 and 4 are correct
D. 1 and 4 are correct - Creep is the_______________?
A. longitudinal movement of rail
B. lateral movement of rail
C. vertical movement of rail
D. difference in level of two rails
