An ideal fluid is_______________?

Related Mcqs:

1. When an ideal fluid flows past a sphere________________?

   A. highest intensity of pressure occurs around the circumference at right angles to flow
   B. lowest pressure intensity occurs at front stagnation point
   C. lowest pressure intensity occurs at rear stagnation point
   D. total drag is zero

2. In steady flow of a fluid, the total accele ration of any fluid particle______________?

   A. can be zero
   B. is never zero
   C. is always zero
   D. is independent of coordinates

3. If the dynamic viscosity of a fluid is 0.5 poise and specific gravity is 0.5, then the kinematic viscosity of that fluid in stokes is__________________?

   A. 0.25
   B. 0.50
   C. 1.0
   D. none of the above

4. The shear stress distribution for a fluid flowing in between the parallel plates, both at rest, is_______________?

   A. constant over the cross section
   B. parabolic distribution across the section
   C. zero at the mid plane and varies linearly with distance from mid plane
   D. zero at plates and increases linearly to midpoint

5. A fluid of kinematic viscosity 0.4 cm2/sec flows through a 8 cm diameter pipe. The maximum velocity for laminar flow will be__________________?

   A. less than 1 m/sec
   B. 1 m/sec
   C. 1.5 m/sec
   D. 2 m/sec

6. If the weight of a body immersed in a fluid exceeds the buoyant force, then the body will________________?

   A. rise until its weight equals the buoyant force
   B. tend to move downward and it may finally sink
   C. float
   D. none of the above

7. The position of center of pressure on a plane surface immersed vertically in a static mass of fluid is______________?

   A. at the centroid of the submerged area
   B. always above the centroid of the area
   C. always below the centroid of the area
   D. none of the above

8. The ratio of average velocity to maximum velocity for steady laminar flow in circular pipes is_______________?

   A. 1/2
   B. 2/3
   C. 3/2
   D. 2

9. For hydro-dynamically smooth boundary, the friction coefficient for turbulent flow is_______________?

   A. constant
   B. dependent only on Reynolds number
   C. a function of Reynolds number and relative roughness
   D. dependent on relative roughness only

10. The theoretical value of coefficient of contraction of a sharp edged orifice is_______________?

    A. 0.611
    B. 0.85
    C. 0.98
    D. 1.00