The risk coefficient k, depends on__________________?

Related Mcqs:

1. The external wind pressure acting on a roof depends on__________________?

   A. degree of permeability of roof B. slope of roof C. both (A) and (B) D. none of the above...

2. The internal pressure coefficient on walls for buildings with large permeability is taken as_______________?

   A. ± 0.2 B. ±0.5 C. ± 0.7 D. 0...

3. In moment resistant connections, the moment resistance of riveted connection depends upon________________?

   A. shear in rivets B. compression in rivets C. tension in rivets D. strength of rivets in bearing...

4. Efficiency of a riveted joint, having the minimum pitch as per IS : 800, is_________________?

   A. 40% B. 50% C. 60% D. 70%...

5. The slenderness ratio of a column supported throughout its length by a masonry wall is________________?

   A. zero B. 10 C. 100 D. infinity...

6. The slenderness ratio of lacing bars should not exceed________________?

   A. 100 B. 120 C. 145 D. 180...

7. If the floor is supported at or near the bottom but top chords of a bridge are not braced, then the bridge is called________________?

   A. deck type B. through type C. half through type D. double deck type...

8. The moment of inertia of the pair of vertical stiffeners about the center line of the web should not be less than__________________?

   A. 1.5dV/C B. 1.5d¥/C C. 1.5d¥/C2 D. 1.5dY/C3 where, ‘t’ is the minimum required thick-ness of the web and ‘C is the maximum permitted clear distance between vertical stiffener for thickness ‘t’...

9. The portal bracing in a truss bridge is used to_____________________?

   A. transfer load from top of end posts to bearings B. keep the rectangular shape of the bridge cross-section C. stiffen the structure laterally D. prevent the sidesway buckling of top chord...

10. To minimize the total cost of a roof truss, the ratio of the cost of truss to the cost of purlins shall be_______________?

    A. 1 B. 2 C. 3 D. 4...