A. 3t
B. 4t
C. 6t
D. 8t
where t = thickness of the batten plate
Advertisement
Related Mcqs:
- In moment resistant connections, the moment resistance of riveted connection depends upon________________?
- A. shear in rivets B. compression in rivets C. tension in rivets D. strength of rivets in bearing...
- The use of tie plates in laced columns is_________________?
- A. prohibited B. not prohibited C. permitted at start and end of lacing system only D. permitted between two parts of the lacing...
- As per IS : 800, for compression flange, the outstand of flange plates should not exceed________________?
- A. 121 B. 161 C. 201 D. 251 where t = thickness of thinnest flange plate...
- Rivets connecting flange angles to cover plates in a plate girder are subjected to_________________?
- A. horizontal shear only B. vertical load only C. both (A. and (B. D. none of the above...
- The allowable tensile stress in structural mild steel plates for steel tank is assumed as________________?
- A. 95.0 MPa on net area B. 105.5 MPa on net area C. 105.5 MPa on gross area D. 150.0 MPa on gross area...
- The minimum thickness of plates in a steel stack should be___________________?
- A. 4 mm B. 5 mm C. 6 mm D. 8 mm...
- Pitch of tacking rivets, when double angles connected back to back and acting as tension members should not be more than_________________?
- A. 500 mm B. 600 mm C. 1000 mm D. 300 mm...
- The maximum slenderness ratio of a steel column, the design of which is governed by wind or seismic forces is________________?
- A. 150 B. 180 C. 250 D. 350...
- The effect of racking forces is considered in the design of_________________?
- i) lateral braces ii) chord members The correct answer is A. only (i) B. only (ii) C. both (i) and (ii) D. none of the above...
- The centrifugal force due to curvature of track is assumed to act on the bridge at a height of___________________?
- A. 1.23 m above the rail level B. 1.50 m above the rail level C. 1.83 m above the rail level D. 2.13 m above the rail level...
Advertisement
