A. 3
B. 5
C. 6
D. 7
Related Mcqs:
- The maximum slenderness ratio of a steel column, the design of which is governed by wind or seismic forces is________________?
A. 150
B. 180
C. 250
D. 350 - As per IS : 875, for the purposes of specifying basic wind velocity, the country has been divided into_____________________?
A. 4 zones
B. 5 zones
C. 6 zones
D. 7 zones - As compared to field rivets, the shop rivets are________________?
A. stronger
B. weaker
C. equally strong
D. any of the above - The maximum slenderness ratio of a compression member carrying both dead and superimposed load is___________________?
A. 180
B. 200
C. 250
D. 350 - The use of tie plates in laced columns is_________________?
A. prohibited
B. not prohibited
C. permitted at start and end of lacing system only
D. permitted between two parts of the lacing - The relation between intensity of wind pressure p and velocity of wind V is taken as_______________?
A. pa V
B. paV2
C. p a (1/V)
D. paV”2 - Which of the following conditions is to be satisfied both in elastic and plastic analysis ?
A. equilibrium condition
B. yield condition
C. plastic moment condition
D. mechanism condition - The shape factor of an isosceles triangle for bending about the axis parallel to the base is________________?
A. 1.5
B. 1.7
C. 2.0
D. 2.34 - The basic wind speed is specified at a height ‘h’ above mean ground level in an open terrain. The value of’h’ is__________________?
A. 10 m
B. 20 m
C. 25 m
D. 50 m - The overlap of batten plates with the main members in welded connections should be more than____________________?
A. 3t
B. 4t
C. 6t
D. 8t
where t = thickness of the batten plate
