The maximum permissible span of asbestos cement sheets is______________________?

Related Mcqs:

1. Normally, the angle of roof truss with asbestos sheets should not be less than_______________?

   A. 26’/2° B. 30° C. 35° D. 40°...

2. If the loaded length of span in meters of a railway steel bridge carrying a single track is 6 m, then impact factor is taken as_________________?

   A. 0 B. 0.5 C. between 0.5 and 1.0 D. 1.0...

3. If the thickness of thinnest outside plate is 10 mm, then the maximum pitch of rivets in tension will be taken as______________?

   A. 120 mm B. 160 mm C. 200 mm D. 300 mm...

4. According to IS Specifications, the maximum pitch of rivets in compression is_____________________?

   A. lesser of 200 mm and 12 t B. lesser of 200 mm and 161 C. lesser of 300 mm and 32 t D. lesser of 3 00 mm and 24 t where t is thickness of thinnest outside plate or angle...

5. The maximum slenderness ratio of a steel column, the design of which is governed by wind or seismic forces is________________?

   A. 150 B. 180 C. 250 D. 350...

6. The maximum slenderness ratio of a compression member carrying both dead and superimposed load is___________________?

   A. 180 B. 200 C. 250 D. 350...

7. Maximum pitch of rivets, used in steel stacks, is limited to_______________?

   A. 6t B. 101 C. 121 D. 161 where t is thickness of thinner plate being connected...

8. In case of plastic design, the calculated maximum shear capacity of a beam as per IS:800 shall be________________?

   A. 0.55 Awfy B. 0.65 Awfy C. 0.75 Awfy D. 0.85 Awfy where, Aw = effective cross-sectional area resisting shear fy = yield stress of the steel...

9. The maximum spacing of vertical stiffeners is_________________?

   A. 1.33 d B. 1.25 d C. 1.5 d D. 1.75 d where d is the distance between flange angles...

10. The heaviest I-section for same depth is_________________?

    A. ISMB B. ISLB C. ISHB D. ISWB...