The least dimension in case of a circular column of diameter D is taken as_______________?

Related Mcqs:

1. In case of timber structures, the form factor for solid circular cross-section is taken as_________________?

   A. 1.18 B. 1.414 C. 1.67 D. 1.81...

2. The difference between gross diameter and nominal diameter for the rivets up to 25 mm diameter is__________________?

   A. 1.0 mm B. 1.5 mm C. 2.0 mm D. 2.5 mm...

3. The relation between intensity of wind pressure p and velocity of wind V is taken as_______________?

   A. pa V B. paV2 C. p a (1/V) D. paV”2...

4. The internal pressure coefficient on walls for buildings with large permeability is taken as_______________?

   A. ± 0.2 B. ±0.5 C. ± 0.7 D. 0...

5. The live load for a sloping roof with slope 15°, where access is not provided to roof, is taken as_______________?

   A. 0.65 kN/m2 B. 0.75 kN/m2 C. 1.35 kN/m2 D. 1.50 kN/m2...

6. A circular column section is generally not used in actual practice because________________?

   A. it is uneconomical B. it cannot carry the load safely C. it is difficult to connect beams to the round sections D. all of the above...

7. According to IS Specifications, the effective length of a column effectively held in position at both ends and restrained in direction at one end is taken as________________?

   A. 0.67 L B. 0.8 L C. L D. 1.5 L...

8. The slenderness ratio of a column supported throughout its length by a masonry wall is________________?

   A. zero B. 10 C. 100 D. infinity...

9. Angle of inclination of the lacing bar with the longitudinal axis of the column should preferably be between____________________?

   A. 10° to 30° B. 30° to 40° C. 40° to 70° D. 90°...

10. The effective length of a battened column is increased by_________________?

    A. 5% B. 10% C. 15% D. 20%...