The effective length of a battened strut effectively held in position at both ends but not restrained in direction is taken as________________?

Related Mcqs:

1. According to IS Specifications, the effective length of a column effectively held in position at both ends and restrained in direction at one end is taken as________________?

   A. 0.67 L B. 0.8 L C. L D. 1.5 L...

2. The effective length of a battened column is increased by_________________?

   A. 5% B. 10% C. 15% D. 20%...

3. The effective length of a fillet weld should not be less than___________________?

   A. two times the weld size B. four times the weld size C. six times the weld size D. weld size...

4. If the loaded length of span in meters of a railway steel bridge carrying a single track is 6 m, then impact factor is taken as_________________?

   A. 0 B. 0.5 C. between 0.5 and 1.0 D. 1.0...

5. The allowable tensile stress in structural mild steel plates for steel tank is assumed as________________?

   A. 95.0 MPa on net area B. 105.5 MPa on net area C. 105.5 MPa on gross area D. 150.0 MPa on gross area...

6. A steel beam supporting loads from the floor slab as well as from wall is termed as________________?

   A. stringer beam B. lintel beam C. spandrel beam D. header beam...

7. The relation between intensity of wind pressure p and velocity of wind V is taken as_______________?

   A. pa V B. paV2 C. p a (1/V) D. paV”2...

8. The internal pressure coefficient on walls for buildings with large permeability is taken as_______________?

   A. ± 0.2 B. ±0.5 C. ± 0.7 D. 0...

9. The least dimension in case of a circular column of diameter D is taken as_______________?

   A. 0.5 D B. 0.68 D C. 0.88 D D. D...

10. In case of timber structures, the form factor for solid circular cross-section is taken as_________________?

    A. 1.18 B. 1.414 C. 1.67 D. 1.81...